Kenmore Washing Machines - Page 9 - Recent Questions, Troubleshooting & Support
HE4t Elite F02 error code
its the error code for a long drain time most likely you need to check the filter in your pump for obstructions
First if you have a wet vac pull the drain hose out of the drain spout and use the vac to pull the water out of the washer through the drain hose.If not you will need a pair of radiator hose clamps from the auto parts store. Pull the screws from the lower panel at the front of the washer and remove it.in side you will see a rubber hose coming down from the tub to the drain pump. Put the radiator hose clamp there if you didn't have a shop vac.On the front of the pump is a round part with a handle turn that and remove the pump filter .Clean any foreign objects out of the pump and look inside the pump to make sure no impeller blades are broken if any are you will have to replace the pump. put the filter back in and tighten it. If you had to use the hose clamp remove it now.reassemble and don't forget to give the tech his four boxes if this fixes it
My Kenmore Elite he5t steam washer is about 2yrs
F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.
If you remove the top panel, three screws in the back, you will have access to the pressure switch.
With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.
If the fault codes return after doing this, you will likely need to replace the pressure switch.
Also - please be sure to use He soap.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.^@$$
Top load washing machine will not agitate
You may need to replace the agitator cogs, aka "dog ears". They allow the agitator to work in a ratcheting motion. I have a different washer but have had to replace mine several times. They are plastic and just wear down.
What does LE display mean on my Kenmore front loading washer?
LE indicates that motor was locked. The load in the washer was too heavy for it to spin safely at the usual speed. This could be from too many items in the washer or that something is wrong with the washer rotor hardware.
First try resetting the washer, turn off the machine and unplug it (or turn it off at the circuit breaker). Then press and hold the start/pause button for 5 seconds. (This drains the capacitors that hold the error code in the control panel's memory.)
Try running the washer with it empty. If the LE error continues, you need to check the rotor and the rotor position sensor. You may also need to check that the tub is properly balanced and the wiring to the control panel. To access the rotor, unplug the washer and disconnect the washer hoses. With help, place the washer on it's back to access the rotor and the rotor sensor. You'll need a 17mm socket (or an adjustable wrench and a hammer) to loosen the rotor mounting nut. Replace a damaged rotor or sensor. Check the wiring harness to the sensor and make sure that there is no corrosion either at the sensor or the control panel connection. Check the wiring for continuity on all of the pins. Replace damaged wiring.
Please add a comment with the washer model number if you need a parts diagram. I hope this helps.
Cindy Wells
Why is my washer spinning instead of agitating?
Check your cogs. Pull the top off agitator off and look inside.
Depending on model has different typed of cogs that slide and catch when working properly. The do wear out.
Also known as "dog ear cogs". Very cheap parts. $2.
Not finding what you are looking for?