Icon Exercise & Fitness - Recent Questions, Troubleshooting & Support
Epic treadmill t60 is stuck in max incline how do
Usually when stuck at the max up position it indicates that you may need a new incline motor. It is not the sensor. I have been repairing treadmills for 15 years and incline sensors seldom if ever go bad. If can isolate the incline motor using a 110 volt power cord, this may un-jam the motor and get it back down to 0%.
I use www.treadmillpartszone.com for parts.
My treadmill got wet the motor runs but the platform belt wont turn
1) Try to get out the controller board motor, and put In bag dry Rice, by 48 hours.
2) clean the board with special contacts cleaner or board electronic( you can buy from any electronic store).
3) Put again the board in the treadmill, If work is ok, IF not the components like IGBT is fault, Replace the completely board.
Blessing
[email protected]
cell+whatsAPP:+50588611441
My Proform 8.5 personal fitness trainer will no longer work
Hello there, It seems that you have a stuck button or a problem with the ifit card area. Yes I know you probably dont use it but just listen. If you have the demo card for the unit try putting the demo card into the ifit slot and press it in and out a couple of times. This will sometimes correct this problem. If that does not correct it then you will need to replace the console or possibly disconnect the ifit section from the console itself. Either way you will need to remove the console.
If more info is needed please leave me a note here and I will get back to you asap.
Good Luck! Tim
Not finding what you are looking for?
