Ibanez Music - Recent Questions, Troubleshooting & Support

Question edited for clarity and toss in some CAPS. Question moved from Refrigerators to model category. This look like a push to turn on, and push again to turn off? They work on a ratchet and are unreliable.. Here are parts suppliers and a link to the maker. They should send you one under warranty. https://www.google.com/search?q=ibanez+tone+blaster+amp+head+parts ..

There is little data on the internet about this... However my AEL20E uses 2 AA cells. Some older ones may have used a 9 volt battery. Yours should use the 2 AA cells which go into the box right by the XLR output plug.

this should help you. https://gearspace.com/board/geekzone/735580-power-supply-ceramic-caps-burnt.html It is a known issue https://music-electronics-forum.com/forum/schematic-requests/27983-ibanez-swx100-combo-bass-amp More here https://www.google.com/search?q=ibanez+bass+amp+swx100+schematic ..

it was one of the first original designs the company produced. this series has all the staples this brand is famous for fast necks, floating terms, and high octane distortion. it is worth about 350.00$.

Koinqq: Situs PokerQQ Domino99 BandarQ Online Terpercaya https://koinqq.top

Try here: https://www.manualslib.com/manual/491791/Ibanez-Tone-Blaster-100r.html

It calls for a stereo input jack? I'm not sure but I think It is probably calling for a 1/4 unbalanced input jack , keeps your signal mono. so if you are only getting the bridge pickup. You might check your position switch. and or your lead pick up. simply take the designated wire from the lead pick up and hook it up where your bridge position pick up is connected. (disconnect that first) if you get sound, then it just may be your switch. if you get nothing? check to make sure you have your ground correct and he lead wire correct. If these are active pick ups? you''ll need a battery source. if stil get nothing. your pick up may be bad.Thats a reads digest troubleshooting explanation. check your basics first. good luck

i believe you need a 1/4" unbalance plug for the amps input. Basically a guitar cord. If I am understanding the question. ? or if you want to know the actual "input jack",Maybe it is lacking or missing? than that would be a "1/4" unbalanced input jack". good luck, I hope this helps.

And what serial number is it?

https://www.talkbass.com/threads/wwyd-ibanez-edc700.1281051

Ibanez guitars have used serial numbers since the mid 1970s. Some sources say the practice started in September 1975, but serial numbers indicating production as early as October 1974 have been spotted.

put a battery in your guitar. It goes in the space at the bottom, usually where you connect your cable to your amp. Then hold the guitar as you usually would. Look for a little board with buttons on the side of the guitar to turn on the tuner: )

fixya doesnt do appraisals notify a music shop

I suspect it is. It's easy enough to wire it up and check.

The internal workings of the guitar - pickups, potentiometers, switches are not grounded. Very common.

Know the year etc? Ibanez have them on-site. Ibanez com Wiring Diagrams

Do NOT modify the guitar. Take it to a shop where they can set it up properly if you are having intonation or clearance problems. Also the quality of strings has a lot to do with changes in tuning. It is NOT uncommon for a guitar to require tuning during a half hour of playing. This is normal, especially if you are really driving it. Temperature affects the tuning drastically as well.

The truss rod in the neck needs adjusting to rid the buzzing sound. I’m happy to help further over the phone at https://www.6ya.com/expert/phillip_293d34ebcf028794

Either you can get it online or go to Ibanez.com and you will locate what you need through this site I’m happy to help further over the phone at https://www.6ya.com/expert/phillip_293d34ebcf028794