My 2003 Ford Windstar recently had a new fuel injector installed after running rough. It still lacks full power while driving it. Mechanic has had it 19 days and still can't find the reason.
There could be several possible causes for the power loss, such as a bad battery, a faulty alternator, a clogged fuel filter, a damaged wiring harness, or a parasitic power draw.
To diagnose the problem, you may need to test the battery voltage, the alternator output, the fuel pressure, and the electrical current draw. You can also check the battery cables and terminals for corrosion, and the fuses and relays for any signs of damage.
Where is the fuel tank pressure sensor located (2010 ford escape 2.5L?) Code P0451
The fuel tank pressure sensor in a 2010 Ford Escape is part of the vehicle's fuel pump assembly. You will find it either inside the tank or mounted to the top of the tank. The P0451 code indicates that the EVAP system pressure sensor is malfunctioning in some way. This code is usually caused by either a bad EVAP pressure sensor, a clogged fuel tank relief valve, EVAP lines, EVAP wiring, or a bad fuel cap. If you have other EVAP related trouble codes, it is recommended to focus on them first and see if it helps remedy this one.
Repair 1999 F250 shifter
I had the same problem. Remove the fuse panel, look up under the dash, move your shift lever back and forth and you will see the shift linkage. There are two screws that will back themselves out over time. It will be a star head bolt. Tigthen them all the way down and it will shift like new.
Inconsistent Cam Phaser Rattle
If the engine is covered by warranty, I would get both of them replaced, (depending on the engine) as there is an issue with the early design.
The dealership will try to fob you off as it is a horrible job.
My ford figo petrol indicators are not working
I suggest you take your car to a certified Ford mechanic to diagnose the issue. In the meantime, here are some possible causes of the problem:
Blown fuse: Check the fuse box and replace any blown fuses .
Faulty flasher relay: A faulty flasher relay can cause the indicators to stop working. A mechanic can replace the relay if necessary.
Bad bulb: Check the bulbs and replace any that are burnt out or damaged .
Defective connector: Check the connectors between the flasher and the switch. If they are defective, they may need to be replaced.
Not finding what you are looking for?