Before you start to disassemble the unit, turn each beater and
see if there is any play in them. Neither should turn without turning the
motor shaft. I think you will find that one or both is turning
independent of the other beater. One should not turn without turning the
other and the motor shaft.
The beaters slide into plastic gears and the gears are turned by the metal gear
on the armature. Usually the metal gear will strip one or both of the
plastic gears when too much pressure is placed on them. This is a safety
issue. If you would get a hand caught in the beaters, the plastic will
strip and save your fingers. This is all good except that the plastic
gears worn out as they are very soft. Then when too much pressure is
placed on the beaters the gears strip.--------Getting parts for this mixture is not very easy.you will have to try local mixer repair service center.The original parts are very difficult to get,but you can get near to same parts from local mixer and electrical appliance parts repair store in your area.------------ The parts are difficult to get because Farberware never made a mixer. They bought their mixers
from outside vendors such as Sunbeam or Hamilton Beach and stamped their name on it. The American Farberware Co.
sold out to a company from China about 10 years and ever since they do not make any parts for
any of their appliances. --------------This should help.Thanks.Helpmech.
8 questions posted
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions