Decker Drills - Recent Questions, Troubleshooting & Support
Black and Decker 18 V 18 V battery charger light stays on red doesn't Flash just stays red and the battery doesn't charge Why is that and how can I Fix it
There could be several reasons why the Black and Decker 18V battery charger's light stays red and the battery doesn't charge. Some possible causes include:
- The battery is not properly seated in the charger. Make sure the battery is securely inserted into the charger's battery compartment.
- The battery is damaged and cannot be charged. Try using a different battery to see if it charges properly.
- The charger is not functioning properly. Try using a different charger to see if it charges the battery.
- The outlet or power source you are using is not providing enough power. Try plugging the charger into a different outlet or using a power strip with surge protection.
- The charger's fuse is blown or the charging contacts are corroded or dirty. Clean the contacts and check for a blown fuse.
If none of these solutions work, it may be best to contact Black and Decker's customer service for further assistance or to get a replacement.
Stuck drill bit in black and decker 18v cordless drill
Lock the chuck and undo the collar. Lock is midway between Screw and Unscrew.Or if it is stuck because the drill was really too big, put the drill on the floor and hold it with your foot, grip the drill with channel lock pliers and hit the jaws with a hammer away from the drill.
Black n decker lithium battry charger keeps flashing red
My 20V battery was stored completely discharged for over 8 months. After all that time I bet the battery was holding no charge whatsoever. When you plug a completely drained battery to a charger the charger will experience a big demand in current and will fault out, flashing red. So we need to put just a little bit of charge in the battery for the charger to start working. What I did is with the battery in charger unplug and plug the charger like 10 times. Every time you plug it in it will send voltage to the battery for a split of a second before the charger fails. Eventually the battery will get enough charge for the charger to start working.
Black and Decker 1309 Drill
When replacing the cord on a 1309 it is probably better to leave the original contact points in place and simply splice into the wires inside the handle. To remove the plastic housing has many tiny spring steel parts that do not reassemble well. Also they have a tendency to fly away when disassembling.
Not finding what you are looking for?