Water Filters & Coolers - Page 3 - Recent Questions, Troubleshooting & Support

Mark and unhook all the tubes from the filter. Take it out and place it on a table horizontally. This is all about correct leverage. While holding the reverse osmosis system in one hand, slide the wrench into a canister and turn it counter-clockwise. If this still does not work, you may have to soak the filter canisters (bottom housing part ONLY) in warm water with vinegar and try the steps above again. How to change 10 RO Pre Filters

There might be a low pressure sensor inside the purologix system that is preventing the cooler from dispensing water. In that case you may need to install a booster pump to increase water pressure into the storage tank of the ro system. Check if you installed the ice maker correctly as well. https://www.wecofilters.com/pub/media/productattach//i/c/ice_maker_kit_manual.pdf

even if you get the top of the line water filter on the market, it will probably say that it is only 99.9% effective

The tank should have only 5-10 psi when empty of water. If your unit sat for any amount of time your reverse osmosis membrane may have a problem. was all the cartridges changed? Should be yearly.

That reddish "sand" is the water softener resin, the material that softens your water.

Not knowing what brand or type it sounds like the advancing motor stopped. You should bypass it and call a service tech.

You are right the valve needs to be repaired or replaced. There are not many easy solutions in life.

Follow the link below:

https://www.myapstore.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-50202-3.pdf

Then go to section labeled "Filter Cartridge Replacement"

Self Cleaning Contact Us Support

My haier does not dispense cold water its dispense warm water

http://www.water-mart.ca/esio/install_guides/Esio-RO-Install.pdf

Bagai mna cara mereset ulang kode pengamanan hp nokia 103

need to repair it

is there a precharge of air in your tank. when empty of water th?re should be about 1 bar or 14psi of air. water must be able to empty from tank. pump air in until all water is gone. if unable to empty tank has failed. also if a pumped unit, when changing filters ensure all air is bled through pump before turning it on toprevent air locking inside pump

unplug for couple of minutes for thermostat to reset then plug it back

check control setting

The refrigeration unit is not working - check out the compressor for proper operation.

I have a hamilton beach water cooler with storage cabinet # 87330. The cold water is not cold and the cooling light stays on. What is the problem and how can I fix it? Thanks!

You have a dead short somewhere. This is why Linda your GFI breker keeps popping. Let us know. May need a new one or is it under warranty? Thank you and leave feedback

The filters that you should replace every the six months are the two pre/post filters (FQROPF). The membrane (FQROMF) needs to be replaced every 1 to 2 years. During the filter change, bacteria could be introduced, so it is recommended that you sanitize the tank while changing the filters. Here are the filters you need to replace:http://www.freshwatersystems.com/p-7787-ge-profile-fqropf-smartwater-ro-pre-and-post-filter-set.aspx