Scuba Diving & Snorkeling - Page 3 - Recent Questions, Troubleshooting & Support
How do I reset code on my gun vault GV2000
Enter the 1,2,3,4 factory number.
When the door opens, immediately press all 4 keys are once and release.
A red light will come on. then enter new code. lamp will turn off.
to confirm the new code enter it a second time.
red light blinks, an error has occurred or your timing was off, so just start over with the factory 1,2,3,4 code.
Spark plugs fireing order
4 cylinder engine is 1-3-4-2. Cylinders are numbered in-line from right to left. That is - Looking into the engine compartment from the front of the car, #1 is on the RIght, #4 is on the left.
--------------------
4 3 2 1
--------------------
6 cylinder is 1-4-2-5-3-6. Looking in.. #1 is on the back Left of the engine with #2 and #3 to it's right. Front left is #4, going to the right are #5 and #6.
--------------------
1 2 3
- - - - -
4 5 6
--------------------
Softener not filtering water through the salt and not draining water from tank
What model of water softener do you have ? The one you have on here is for a chemical, not a water softener. Usually it is the brine injector or commonly called the nozzle/venture that gets clogged and will not create a vacuum to draw out the brine water. If you can put a picture of your water softener on here. I'd be more than happy to help you out.
460 cu spark plug gap
On that big 7.5 liter engine, .042-.046 stock; if hotter cam go .046-.050 and make sure ignition is in good shape. preferrably aftermarket coil at least or ign box set up.
Diesel fuel leaking from top back of motor
You will need to determine where the leak is unless you want to take a more comprehensive approach and replace the fuel lines and plumbing after the HP pump. If you aren't comfortable examining the engine while running with mirrors or even a camera, simply clean it very well and then run for a short time and attempt to determine from the evidence.
Power window not working
First, do you have power to the switch? If not check fuse and wiring. If yes, is switch passing power to motor? If yes but no movement, replace motor.
Good luck!
Radio gas door heater blower does not work what should I be looking for
Multiple component failures suggest a power problem so good call to check fuses. Next step is to look for a wiring diagram to see if they are on the same circuit and either find the power interruption or possibly lost ground.
It is possible that a VAGCOM scan may reveal the problem as well.
Good Luck
11/25/2014 3:21:14 PM •
Neuspeed...
•
Answered
on Nov 25, 2014
How do I change the cabin filter on my 2003 ford f-250
E-series and F-series trucks are made without cabin filters, there are kits you can buy if you want to install one.
that being said, if yours has one it will be up behind the glove box.
I have an 2006 f250 & when I open my glove box, when its open the top is held by a rubber coated tab on each side sticking out that catches on the opening keeping it from falling out.
push inward on each side of the box corner to unlatch them, this will allow the glove box to fall forward to access what is behind it.
behind the glove box there is a panel held in place by 6 -7 or so hex head screws.
the filter if there is one should be behind the panel.
Not finding what you are looking for?