Office Equipment & Supplies - Popular Questions, Answers, Tips & Manuals
Scanner canon dr6030 cants pull the paper
Troubleshoot this issue step by step:
Check the Feed Selection Lever:
Ensure that the Feed Selection Lever (located on the lower left side of the front of the scanner) is in the correct position (up) for separation.
Straighten the edges of the stack of documents to be scanned.
Set the document guides so they are wider than the document to be scanned.
Place the documents face up into the feed tray, ensuring they touch the document stoppers.
Clear Any Jammed Paper:
Be careful when removing jammed paper to avoid cuts.
Remove any documents that have been left in the eject tray.
Close the document eject tray.
If the document ejection is stopped partway, perform this operation with the document eject tray extension open.
Hold the upper unit as shown in the diagram and open it to the point where you can remove the jammed document. The pickup roller is located in the middle of the upper unit. Do not hold the protrusion on the upper unit when opening it, as it may deform the pickup roller or cause a feeding error.
Close the feeder cover.
If the jam occurred in the feed section, pull the document out carefully without applying too much force. Be sure to remove any torn parts remaining in the scanner.
Close the upper unit slowly, ensuring it clicks into place. Do not force it to close, as this may damage the scanner.
After removing the jammed paper, check if the last page was scanned, and then continue scanning.
Rapid Recover System:
If a paper jam occurs when the "Rapid Recover System" is enabled in the ISIS/TWAIN driver settings, the image of the document is not saved, and scanning stops. You can continue scanning from the document that caused the paper jam after fixing the issue.
Additional Considerations:
Make sure the pickup rollers retract when the machine is powered on.
Check that the stopper plates are in the down position.
Verify that the upper unit is completely closed after clearing the jam.
Remember to handle the scanner components carefully to avoid damage. If the issue persists, consider seeking professional assistance or contacting Canon support for further guidance
Why my Trifo Emma not powering/starting after press button Reset? The robot vacuum is dead.
Some times this is just the charging dock not communicating with the actual robot vacuum. What surface is the charging dock sitting on? It works best if it is on a hard surface and Not carpet.
Try this. Remove the vacuum from the charging dock and turn it completely Off. Unplug the charging dock from the wall outlet. Check inside the charging dock at the connection point the robot plugs into. Make sure it's clean. Next check the robot itself to make sure the connector on that is also clean.
Everything needs to be completely turned off for at least 5 minutes. This does a 'Soft Reset' on the Robot's electronics. After 5 minutes fit the robot back into the charging dock, gently but firmly making sure it is all the way in place. Next plug the charging dock back into the wall outlet. DON'T turn the robot back on. Walk away from it for an hour to let the charging dock put some charge into the battery in the robot. After that hour turn the robot back on and see if the issue has changed.
3/12/2024 10:17:21 AM •
The Office...
•
34 views • 0 helpful votes
Epson lq-690II printer reflects the paper when printing
Troubleshooting Paper Reversal in Printers:
*Confirm that options related to paper handling are set correctly by checking for specific buttons or switches that relate to paper handling or reversing.
*Ensure that paper is loaded properly to avoid feeding problems.
*Remove any dust, particles, or paper remnants from the rollers, as they can impede paper flow.
*If other measures fail, reset the printer to its initial settings to resolve potential software glitches.
Not finding what you are looking for?