Kitchen Ranges - Recent Questions, Troubleshooting & Support


I had checked the "connection" at the blanket before but after reading this I unplugged it from the wall and re-checked the plug in at the blanket. It's not flashing anymore and it seems to be working.

From Sunbeam's site:

Q: What does "FF" mean on display of my control?
A: If you have a digital control, it is designed to flash "FF" on the display to notify you that a problem may have been discovered. Gradient controls and warming throw controls use a blinking indicator light for this purpose.

Follow the instructions on the flag tag to reset the control or follow the steps below.
  • Unplug the system from wall outlet.
  • Check that the control is well connected to the module.
  • Plug the power cord into the wall outlet.
  • Set the control to "on".
If the system still does not operate, disconnect the power cord and Contact Us.

Frigidaire... | Answered 57 minutes ago


Many ovens built by GE display error codes on the display when problems are detected. The F7 error code indicates that there is a problem with the buttons of the control panel. The code comes on when two or more buttons are stuck at the same time. The oven cannot operate when this condition exists. The oven is repaired by replacing the control panel with a functioning one.
Follow the steps
1. Unplug the oven power cord from the electrical outlet.
2.
Open the oven door fully. 3. Unscrew and remove the two or three screws from the inside of the oven that hold down the control panel.
4. Pull the control panel toward the front of the oven. Lift the panel up to disconnect it from the oven.
5. Rotate the control panel sideways to get easy access to the data cable.
6. Remove the screws that hold the data-cable connector. Disconnect the data cable. Set the old control panel aside.
7. Plug the data cable into the new control panel. Replace the screws that hold the cable connector into the control panel.
8. Position the control panel in its correct position on top of the GE oven. Replace the screws on the bottom of the control panel from the inside of the oven.
thank you

GE Kitchen... | Answered 2 hours ago


Call 1800 GE CARES , or schedule a service appointment online at www.geappliances.com

GE Kitchen... | Answered 4 hours ago


Don't fiddle with gas - get a technician or increase your fire insurance.

Bosch Kitchen... | Answered 3 days ago


you dont want to use oil you want
pick up some not stick spay like pam
just spray it into the part of hinge you can see
after a few open and close the sqeek should go away

Kitchen Ranges | Answered 3 days ago


oven burners ignitors weak and/or valve faulty
top burners regulator issue
you should call for service

Viking Kitchen... | Answered 3 days ago


use some packing tape stick it on light lens to turn
the hood came with a suction cup for unscrewing bulbs
you could order through dacor or find one in dollar store

Dacor Kitchen... | Answered 3 days ago


you have to turn all knobs to off including the outer selector dials on the outer part of oven temp knobs
once everything is turned to off shut breaker down for 2 min then turn on should reset

Thermador... | Answered 3 days ago


with manual stat the control when turned on is on bake
once you go to broil it locks into broil
in order to go back to bake you have to go back to off position and then on to temp to reset back to bake

Kitchen Ranges | Answered 3 days ago


older viking have large round nut with 2 holes
you can insert needle nose pliers into holes to turn
you can also use pipe wrench on round part of nut
if the nut is seised on you may have to drill out and replace nut and jet holder that nut screws onto

Viking Kitchen... | Answered 3 days ago


mfg only suggest calabrating up to 50 deg
if you are burning you are way past 50 deg so you should replace stat

AGA Kitchen... | Answered 3 days ago


set oven into self clean wait till it says door locked and on and then cancel cycle after a couple min should unlock if not you may need lock
there is no safty latch ther is door removal latch on hinges if these were in hold position the door would not close

Bosch Kitchen... | Answered 3 days ago

Not finding what you are looking for?
Kitchen Ranges Logo

51,871 questions posted

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Marvin
Marvin

Level 3 Expert

83851 Answers

Paul Carew

Level 3 Expert

3411 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...