Cooktops - Page 7 - Recent Questions, Troubleshooting & Support
My candy ceramic hob alternating flicking F and H? What's wrong?
The 'H' symbols will flash in the display the first time your hob is connected and switched on. This is because the hob has been heat tested at the factory, then switched off while still hot. This may also happen if you are using the hob and you have a power cut.
Error code F1 indicates that the power is too low due to unsuitable cookware or an empty pot. Error code F indicates that there is no cookware on the zone or the cookware is unsuitable.
..
GE Cooktop drop-in model # jgp328bec2bb - how to
Turn off the gas,unplug the power.
Take the cooktop out of the cutout and support it on the countertop.
Remove all grates and valve knobs.
Remove all screws from the valves and the burners.
Remove the burner base plates.
You may have screw on the side holding the top to the base,if so,remove these too.
The top will separate from the bottom exposing your parts.
I Bought Prestige induction stove
E5 or E0 means that the stove is getting overheated. You have to reduce the temperature for it to stop. It goes on with few beeps and then stops.
MY ELECTRIC RANGE KEEPS NEEDING TO BE RESET. iS IT A PART SHORTING OUT OR IS IT THE WRONG AMPERAGE FOR THE OUTLET?
It depends on several factors. First, I'll assume when you "reset" the range, you are resetting the circuit breaker (cb) in the cb panel.
If this is the case then there are two possible causes. 1. The cb is old and worn out. So replace it. 2. There is an occasional overload of the circuit. This causes the cb to trip. For that you will need a qualified electrician to determine what is causing the overload. WARNING!!! Ranges are typically 220 Volts which can kill a person. So leave this up to the pros. Do Not attempt to do this work yourself.
6/29/2021 11:49:00 PM •
Cooktops
•
Answered
on Jun 29, 2021
Miele KM-493 induction stove. What does error E13 indicate?
- Error code E13 error showing on display
- What causes an E13, E 13 error code on the Induction Cooktop control panel?
- Error code 13 on Induction Cooktop control panel
Cause:
- Universal OFF key failure
Troubleshooting:
- If the controls are wet or water made contact with them, dry off the controls.
- Turn off then back on to reset.
- If the error persists, reset the unit at the circuit breaker.
- Turn the unit back on to see if the error code cleared.
Not finding what you are looking for?