Question edited for clarity.
Although this guy makes it look hard work, they will usually bounce open quicker that this. You can also bang the top with a rubber mallet, or use a rare earth puck magnet to pull the actuator bolt.
Question edited for clarity.
Question moved from Heating and Cooling.
You can open it with the backup key and replace the depleted batteries. Then reset a new combination.
All this type of safe can be opened with a large rare earth magnet faster than using the combination!
Sorry for your loss.
Electronic safes are very easy to open, there is the slap method, the bump method, the rubber mallet method and the rare earth puck magnet method. Or a local Locksmith can do it. The article and videos show all the ways
The video shows one way, but the easy way is open it with the back up key, and the battery compartment is in the door. Replace the batteries and reset the combination, but make sure you do it with the door open.
UserManual.wikihttps://usermanual.wiki > ...
PDF
Slide the Battery Cover off of the Battery Compartment, remove used Batteries, and insert four new "4, AA" Batteries. Once you have changed the Batteries, be ...
4 pages
If your Sentry Supreme 5330 safe is not opening, there could be a few possible reasons why:
Combination Error: If you are using a combination to open the safe, make sure that you are entering the correct combination. If you have forgotten the combination, you will need to contact Sentry Safe customer service to get assistance on how to recover or reset your combination.
Dead Batteries: If you have an electronic lock on your safe, the batteries may be dead. Replace the batteries and try again.
Jammed Bolts: The locking bolts may be jammed due to incorrect operation or a mechanical problem. Try tapping the safe door gently with a rubber mallet to loosen the bolts and then try to open it.
Mechanical Malfunction: If the safe still does not open, there may be a mechanical malfunction. In this case, you will need to contact a professional safe technician to diagnose and repair the problem.
Note: If you have lost your key, you will need to contact Sentry Safe customer service to order a replacement key.
Lubriplate Low-temp Multi-purpose, Low Temperature Grease, the same grease used for Genie garage door openers. When i used other types of grease, the opener would squeal when the temperature was low.
Question edited for clarity. Please don't type in all CAPS, it is considered SHOUTING and is harder to read.Question moved from Washing Machines Category.Is it hard wired or battery powered? Replace batteries. Remove the cover and vacuum it with the circular vacuum brush.If it is older than 10 years it needs replacing. If it is a Kidde, there is a hard wired electronic timer in it that beeps at 10 years and doesn't stop. It is written in tiny writing on the back. I found that out the hard way. :>)There is also the possibility that there is a constant Co2 source from something, heater, furnace, stove etc.https://www.google.com/search?q=why+does+my+co2+alarm+keep+beepingAlso, Carbon Monoxide is CO, not Co2 (Carbon DiOxide). Unless you are in a beer cellar with Co2 dispense by a gas bottle. I had one, I owned a pub...
This is an unknown maker where we are in North America. It sounds like the board has failed. Open with the key and call a locksmith.
https://www.google.com/search?q=wansa+safe
..