Home Fencing - Page 3 - Recent Questions, Troubleshooting & Support

Check for obvious bad contacts. The next thing to check is the loop detector itself. Since you are checking inductance measured in Henry's it would be good to get the specs from manufacturer Try calling customer service.

If you dont already have this: try adding sod, some mulch and afew plants (with colors). But keep in mind it should have low maintenance. Alot of homebuyers like low maintenance. Something that they can do themselves or hire someone to do cheap. Please see below for example. Hope this helps!

May just be a linkage adjustment. Check for recalls on your vehicle.

700 + 264 =964 perimeter

Remove all batteries for 1 minute, should work

Check the timer switch in the control box.

Check to see if the screw retractor is stuck.

The controller most likely needs to be re-calibrated. We had the same problem and called the company, who reset the travel and stop settings. Apparently this can happen if the gate / gearing assembly goes 'off-track' and skips some teeth. So call a tech who's qualified in this model, or go to the website for this MM560, and download the manual. My two cent's worth, anyway. :)

9 out of 10 times its the Valve in the rear of the piston housing the one that you pull the lever to let it downor kick with your foot as the valve return isent returning.back to the header tank..

Of course it depends on the dimentions of your yard. Wooden fences can be quite expensive. look at this site, it includes installation costs: http://www.homewyse.com/costs/cost_of_wood_fencing.html

6.828283 acres. ( 1 acre = 43560 sf ) 260'×1144' = 297440 sf. Divide that by 43560 = 6.828283 acres.

follow the link New updated files for fuse box location t300 kenworth

Check the relay that operates the lock on the controller circuit board. It probably is bad.

Is the fuel tank contaminated with dirt or other particles that may be clogging the carb? I have seen this many times.

It means that it has not accepted it ie not compatable or damaged taken too long to do the prcedure or wrong procedure hope this helps

It means that it has not programmed your new remote ie not compatable with your system or damaged hope this helps

Hi, 5,000 square feet.