Hand Tools - Page 7 - Recent Questions, Troubleshooting & Support
Mastercraft mitre saw
with regards to the stanley power stapler gun............replace the micro switch
12/4/2013 8:57:06 AM •
Hand Tools
•
Answered
on Dec 04, 2013
Stanley electric staple gun tre550
Javid Vossough solution will not work, yes it will fire one staple/nail but then nothing as the circuitry to the micro switch is needed to return the solenoid operated hammer inside the gun
Need attic insulation for ladder area
Buy some styrofoam panels at the hardware store. They're usually 2"x2'X4" and they only cost a few dollars. Also get a small tube of construction adhesive. Stick them to the top side. Styrofoam if one of the best insulators you can but. I have it on the inside, of my metal basement door. In the winter, when the temperature drops to 10 °, my cellarway maintains about 65°.
!/16" thick styrofoam protesct your hand from 170° coffee.
12/3/2013 4:17:13 AM •
Hand Tools
•
Answered
on Dec 03, 2013
Motor burned out
I got a good one on e-bay, now I have lots of bits!
11/28/2013 12:44:10 AM •
Hand Tools
•
Answered
on Nov 28, 2013
Parts
I have the same sander, and cannot get parts anymore, so I carefully cut out a piece of sheet metal, and drilled holes, and put it on. so it might not say stanley, but who cares? I don't. and if it doesn't last as long, who cares. its more help than I got from stanley, who was bought out in 1973 from what I read.
I bought a used stanley
There will be a button to push in which will lock the spindel. After locking the spindel you need to undo a nut using a wrench or spanner.
When I attempt to pump the jack up it will not
Either the pressure release valve is loose or the seals are worn out. Make sure the screw valve is tight. If that doesn't fix the problem, buy another jack. The seals really aren't user replaceable.
10/15/2013 3:56:57 PM •
Hand Tools
•
Answered
on Oct 15, 2013
My PHT150 SharpShooter is jammed
Sometimes a bit of the staple material will be sheared off and jam the hammer in its guide, keeping the tool compressed. On the business end of a PHT150 there is a notch in the hammer housing and a slot on the staple carrier. Most times a standard screwdriver can be used by sticking the tip straight into the slot and using the notch to leverage the the two apart. If not, you can clamp the hammer housing in a vise and, using the screwdriver in the carrier slot, tap away from the hammer housing to release the jamb.
I want to register my
go to the manufacturers site and see if you can down load a pdf file or see if you can enter the details direct
8/2/2013 9:55:06 AM •
Hand Tools
•
Answered
on Aug 02, 2013
Not finding what you are looking for?