Floor Polishers & Buffers - Popular Questions, Answers, Tips & Manuals

I apologize, but I need more information about the specific model of the Eclipse propane floor buffer to locate the manual and provide troubleshooting steps. Can you please provide the model number or any additional details about the buffer?

The rectifier is in the top end of the motor. Take the cover off and then the top end plate of the motor. With the bolts removed, you will have to tap and rock the plate to evenly remove it. Carefully look at the marks on the old and new part to be shur you do not make a mistake in the wiring. A drawing and photo might be nice too.

Use your volt meter to test the battery voltage. It should be at least 12.4v . I this is good, follow the voltage through the ignition switch and the relay if it has one, on to the starter. If you have power on to the starter, but still no crank, the starter is bad. Hope this helps, Robert

Any janitorial supply in your town, or ebay. Your Home Depot or Lowe's may have them as well as Amazon.

Timber Floor Sanding and Polishing Melbourne Use this guy, i have used them before & they are very affordable & professionals for sure

What exactly is the question here? Is this a corded electric Scrubber or a battery one?

The switch has gone bad. Very common on these. The contacts in the switch wear out and then get welded together. The motor draws a lot of power when first started and this is ******* the switch.

Other than design differences tension settings are much the same. Check out these videos and you will probably find your answer. sewing machine tension YouTube

Plug it in,pull trigger

Wax remover. Rewax spot after removing wax.

This is the B-8 model shampooer. I just uploaded it under Electrolux B-8 Shampooer.

www.mastercraft.com/manuals/.../2005_mastercraft_owners

the brush is either dirty or you burned the wax.

The connectors are that thick the cable is thin.

www.cleanfreak.com/Qstore/p001525.htm

www.clarkeus.com

www.sears.com/search=kenmore%20floor..