Cycling - Page 9 - Recent Questions, Troubleshooting & Support
Charger keeps flashing red and
Hi,
Look at the connector end that plugs into the bike. You might have to take it apart to see the wires inside. My son has a Razor Vespa type scooter and the solder job for the wires inside the connector were not the best. It might be a broken wire, especially if it's flashing between red and green.
Hope this Helps!
Please Rate;)
Gary
How to reset a Bell
You can also take off the thin metal piece and just take the numbers off and change it to what you want
11/11/2021 10:54:45 PM •
Cycling
•
Answered
on Nov 11, 2021
How do I insert cable into my Shimano XT SL-M740 3 Speed Rapid Fire Shifter
I finished changing the cable of Shimano Deore XT SL-M740. Unfortunately it did not have the plastic screw hiding the chunk of lead at the end of the cable. I mean that there is no hole from which the cable can be pulled out. Therefore, I removed the front panel where you see "Simano Deore", but this panel only removed the shift position indicator and the internal mechanism was covered by another metal sheet. To change the cable I had to remove the small cover between the barrel adjuster and the lever. The cover is fastened by two very small screws. An encouraging sign was that one of these screws was missing. That indicated that a previous owner had removed the cover once. The cable end was attached to a component exactly like a brake cable is attached to a brake lever. This component pulls the cable around the shifter. The sift cable is not attached to the shift lever. The sift lever rotates the said component. The barrel adjuster had a slot to put the cable inside. Therefore, attaching the cable to the above component was easy. When the cover was installed, I attached the small screw to the end of a driver with silicon paste. Someone suggested to use grease, but grease is messy.
Razor mx350
Have you tried removing plastic chain guard and making sure chain is not off track i had this problem and that is all it was.
Battery cover & battery type for ergometer older unit
The battery cover is no longer made since this bike was last built in the late 1980's. I would recommend giving the man a timer/watch. I do have one of these little black round batter covers, and would sell for $25. However, all it does is create a timer for the rider. He already can use the analog computer to see his mileage, load, and can re-set the lower mileage to zero every workout. All the battery cover will allow is for him to set a timer for how many minutes he wants to workout for. Or he can pust the start button to time his workout. (my email is
[email protected])
How to reset maintenance tray manually
You should only do that once. The maintenance tray needs to be replaced because the wipers and seals to keep your printheads clean need to be occasionally replaced. Not doing so will just damage thousands of dollars in printheads. Call an authorized Canon/Oce technician for parts and service.
9/17/2021 9:07:08 PM •
Cycling
•
Answered
on Sep 17, 2021
Reset procedure
You can reset the maintenance as many times as you like. However, these units do wear out and can be cleaned once, then a replacement is necessary to keep the heads capped and clean. For the price of a new maintenance tray you could be saving yourself thousands in print head replacements. The maintenance tray is a real pain to wash and extremely messy. The ink gets everywhere and you have to rinse out the foam until its clean. It's unbelievable how much ink that foam holds. I guarantee that you'll only clean out the maintenance tray once, and never do it again because of the mess to the sink, area around sink, clothes and hands.
9/17/2021 9:01:47 PM •
Cycling
•
Answered
on Sep 17, 2021
Not finding what you are looking for?