Coffee Makers & Espresso Machines - Page 6 - Recent Questions, Troubleshooting & Support

Question edited for clarity. Turn question around, 'E zero 6' not E small letter o 6. Model Number is useful. I found this on a site that has a malware warning, so I wont provide the link The Hamilton Beach 49966 is a coffee maker that uses both ground coffee and coffee pods. The E06 error code on this model indicates a problem with the water flow sensor. This could be caused by a clogged water filter or an issue with the water pump. Here are some steps you can try to troubleshoot the E06 error code:

1. Clean the water filter: Check the water filter and make sure it is clean and free of debris. If it is dirty, rinse it with water and let it dry before reinserting it into the machine.
2. Check the water tank: Make sure that the water tank is properly seated and has enough water. If the water level is low, refill the tank with fresh water.
3. Clean the water lines: Over time, the water lines inside the machine can become clogged with mineral deposits or other debris. You can try running a descaling solution through the machine to clean the lines.
4. Reset the machine: Unplug the machine from the power source for a few minutes, then plug it back in and turn it on to see if the E06 error code has cleared.

If none of these steps work, the issue may be with the water pump or sensor, and you may need to contact Hamilton Beach customer support for further assistance or to request a repair.

What does the eo6 code mean on Hamilton Beach brew station

perhaps remove the hopper (top) and inspect to see if a buildup of very fine compacted grounds as accumulated. knock the stuff loose.

Claim using this phone number. It says 2 years warranty, but the product link does say 5 years. WARRANTY SERVICE To obtain the warranty coverage stated below, return defective product with proof of original sale to Kenmore (Transformco) authorized retailer from which it was purchased. Call this number to obtain the warranty coverage stated below: 1-800-265-8456 KENMORE LIMITED WARRANTY FOR TWO YEARS from the date of original sale this appliance is warranted against defects in material or workmanship when it is correctly installed, operated and maintained according to all supplied instructions. WITH PROOF OF ORIGINAL SALE a defective appliance will be replaced free of charge. If replacement is not available, the retailer will provide item price credit usable for other purchases from that retailer. This warranty does not cover expendable parts that can wear out from normal use within the warranty period. This warranty is void if this appliance is ever used for other than private household purposes.

Kenmore Elite Brew Coffee Maker with Burr Grinder

Koolatron https://www.koolatron.com > en-ca > products > kenm... Kenmore Elite Grind and Brew Coffee Maker ; Power Type, 120 Volt ; Product Weight, 11.50 lbs (5.29 kg) ; Color, Silver, Black ; Warranty, 5 year limited warranty. $319.00 · ‎In stock

Kenmore Elite Programmable Coffee Maker ' 12-cup

Koolatron https://www.koolatron.com > products > kenmore-elite... Best of all, Kenmore Elite products are backed by a 5-year limited warranty for your peace of mind.

Limited help here, but these machines need dealer service every 6 to 12 months depending on use. Of course they don't tell you this when you buy them. https://www.google.com/search?q=Philips+Lattego+water+light+stays+on ..

Often these temperature differences are solved by descaling. Do never use vinegar. One can buy citric acid crystals or powder (not the same as lemon juice) and dissolve that chemical in water. I buy it in the Chinese Mall. Do not make a too strong acid. Shops sell maintenance powder which is the same but that is quite expensive. Let the acidic water go in and through the coffee maker until it looks clear. Next rinse with water for quite a number of runs. You may see how strong the citric acid that you make is by descaling something else and wait for about an hour. Another acid to be used in coffee makers is lactic acid. Lactic acid is bought as a cleaning agent. Also very strong and to be diluted with water.

I've also had this problem with the Krups 'Il Primo' - reduced steam for frothing of milk but plenty of espresso.Diagnosis: over many uses, a residue of dried milk plugs the interior of the steamer tip.Fix: Using a small adjustable wrench, remove the tip. Clean it inside and out with a tooth pick. Reattach the tip - gentle with the wrench.

there are no repair parts for unit, so there is repair or fic.

if the pot is leaking at or thru power indicator light, there is no repair. The spigot is not available. You can look on eBay for used similar urns.

Every 6 months should be fine.

How to Clean and Maintain A Fully Automatic Espresso ...

Espresso Canada https://espressocanada.com > blogs > news > how-to-cl... Cleaning and Lubricating the Removable Brew Unit Every Three to Six Months · If you brew 1-5 coffees per day, lubricate every 4 months · If you brew 6-10 coffees ...

Hello Philip When you unscrew the burr bolts usually you do it to replace them. The lower burr holder plate must be stopped from spinning with 1 screwdriver put in the exit hole of the coffee and touching the burr holder flaps (usually they are 3 flaps). The screwdriver will block and you can freely work.

unplug machine and turn upside down and pour out coffee and water mix (if water was in reservoir) If necessary turn over and fill will water and repeat.

All your delivery tubes are blocked with congealed sour milk. These machines need cleaning daily with Enzyme milk cleaner like Rinza, but they don't tell you this stuff when you buy them. I spent the last 9 years of my career with high volume coffee machines (1,000 cups a day) and ours were cleaned three times a day. In a previous position where they were actually done once a day, the tubes sometimes had to be removed and cleaned manually. The milk in the tubes was disgusting and stuck to the walls of the plastic tube like glue! They also don't tell you that these machines need dealer service every 6 to 12 months. https://www.google.com/search?q=Chefman+Barista+Pro+Silver+Won%27t+Dispense+Milk ..

Likely cause of this is a blocked worm drive. The worm drive takes the coffee in and then, after brewing, ejects the used grounds into the Dump box. Over time, coffee grounds accumulate on the worm drive and eventually jam it. This is Malfunction 8. Machine will need to be stripped and cleaned. Hope this helps.

Page 14 refers. Error 9. Pump motor rotates too slow or does not rotate at all: ? The pump motor is rotating during machine start?up and during use.

Bolero Turbo (XL) - Abicart

abicart.com https://cdn.abicart.com > shop > art36 > 13416823... https://www.google.com/search?q=BOLERO+XL+Coffee+machine.+It+has+Error+9 ..

I have a hot water bottle that is stuck but its not stuck by the cap where u put water in but the bladder part of the hot water bottle how can I get it so I can put water in it again

The replacement lid can be found at:

http://www.forumappliances.com/i-656-Hamilton_Beach__cover_lid_.html

They only know that the beans is empty when it comes to compressing the grounds into a puck just before brewing. If the brew unit has nothing in the chamber to compress then it assumes you are out of beans.. Remove and thoroughly clean the brew unit and make sure grounds are exiting the grinder when the grinder is running.

I also have the same problem with my xp9000. The beans are grinding but no coffee is expressed.... Any advice????