Radio Communications - Page 3 - Recent Questions, Troubleshooting & Support
148 gtl receive issues
The problem is in the audio output chip usually bolted to the inner chassis. Sometimes the chip developes a hairline crack, replacement recommended.
Why is my icom ic-718 hf radio stuck in tx mode?
It can be a few things but first try resetting your CPU, while your transceiver is off, hold down the UP & DOWN buttons simultaneously then turn the transceiver back on, now it should be reset to the factory default settings
11/29/2023 11:26:24 PM •
Icom Radio...
•
Answered
on Nov 29, 2023
Replace battery h700
Hi there,
Well you can please follow the below step -
1. Make sure you actually need battery replacements. Wrong use of the unit can lead to faulty functioning. If you have recently bought the device, charge the unit for approximately 2 hours and let the unit drain its energy completely before recharging to give the maximum battery life span.
2. Turn off the unit before attempting a battery replacement. Without doing so, the power disruption that the headset will acquire can damage the internal workings.
3. Find the even **** on the bottom side of the unit, where the microphone boom is attached.
4. Place the edge of the flathead screwdriver along these slits, and twist gently back and forth until the unit opens up. Do not completely open the unit up, however.
5. Find the small ring near the plug and the mini-USB port. Use the screwdriver to push under the ring where the battery is found. Push forward gently to pop the battery out. Please post comments for more help or information.........
Good Luck!!
11/26/2023 2:35:03 PM •
Motorola...
•
Answered
on Nov 26, 2023
Does anyone know how to put a barrel pin jack in a radio shack pro 2034 police scanner thanks
To install a barrel pin jack in a RadioShack Pro-2034 police scanner, you will need to follow these steps:
- Locate the appropriate input/output port on the back of the scanner. This is typically a 3.5mm or 1/8-inch jack.
- Gather the necessary tools and materials. You will need a small Phillips head screwdriver, a barrel pin jack, and any connecting wires or cables that are required.
- Carefully remove the back panel or cover of the scanner to access the internal components.
- Locate the input/output port on the circuit board inside the scanner.
- Carefully disconnect any existing wires or cables that are connected to the port.
- Connect the barrel pin jack to the circuit board using the appropriate wires or cables. Make sure to follow the wiring diagram or instructions provided with the jack to ensure proper connection.
- Secure the jack in place using the screws provided, or by soldering the connections if required.
- Replace the back panel or cover of the scanner and test the new barrel pin jack to ensure it is functioning correctly.
It is important to follow the manufacturer's instructions and use caution when installing any components or making modifications to your scanner. If you are unsure about any aspect of the installation process, it is recommended to seek the assistance of a qualified technician or the manufacturer.
Tk 3312 programming help
Hi,I'm guessing you have the software, or you want to obtain the software, either way the solution to your query is right Here: join yahoo group SPECIFIC to your radio Make/Model, the techs there will give you all the help you need, PLUS, you can download manuals, schematic diagrams and yes SOFTWARE for your radio.All this for FREE, I know, I'm a member of another radio group.Good luck and Best regards,Peter
11/11/2023 6:26:56 PM •
Kenwood...
•
Answered
on Nov 11, 2023
Not finding what you are looking for?