Vehicle Parts & Accessories - Page 7 - Recent Questions, Troubleshooting & Support
Sumitomo lt 3400
Ran a 14 or 16 gauge between the starter solenoid (the small wire).
Turn the key to on position
touch POSITIVE position to "HOTWIRE" start your car.
This will confirm it is your electrical ignition switch is bad.
A jump start short circuit
double check the polarity of the unit with a volt meter----
red>>>positive~~~~~~black>>>negative
another thought---after you got your vehicle running did you have any issues later----such as batt going dead again---wipers won't work---lites dim--- etc etc----there a lot of variables here so this isn't going to be easy----get back to me with some answers if you please----it's the best I can do for now
How can put my Avital 7345L remote starter on vibrate instead of chirping?
To put your Avital 7345L remote starter on vibrate instead of chirping, you will need to follow these steps:
- Press and hold the "Valet" button on the remote starter until the parking lights flash twice. This will put the remote starter into valet mode.
- Press and hold the "Lock" button on the remote starter until the parking lights flash twice. This will turn off the chirping feature.
- Press and hold the "Unlock" button on the remote starter until the parking lights flash twice. This will turn on the vibrate feature.
- Press and hold the "Valet" button on the remote starter until the parking lights flash twice. This will exit valet mode and save your settings.
- Test the remote starter to make sure that it is vibrating instead of chirping.
Note: If you have difficulty following these steps or if you have any other issues with your Avital 7345L remote starter, it is recommended that you consult the user manual or contact the manufacturer for assistance.
Sticky interior parts
If you are talking about the plastic parts around the center console, they are sticky most likely because of the heat of the sun and the effect it has on the rubber coated plastics. The only way to correct this is to buy all new parts from Ferrari.
Bulldog Deluxe 500, remote not starting the the vehicle
Remove the battery in your remote for 15 sec, then put back in, start your car with your key, wait 15 sec, while the car is running press the * star button 2 times, it should beep , if not try it again, if still nothing post me back and we can go from there
AS 9903 Car Alarm
Reverse engineer the problem. When did it stop working? Where were you or who drove the vehicle and what happened that may have caused it to stop? Has the battery in the remote just been changed ? Maybe an alarm installer needs to have a look ?
Not finding what you are looking for?