Bosch Washing Machines - Recent Questions, Troubleshooting & Support


Motor carbon brushes burned out and needs to be replaced. You can YouTube the procedure and do it yourself or call a service center and tell them you know precisely was wrong with it and how much to replace the parts and labor. It's a. 45-60 job
good luck

Bosch Washing... | Answered on Jan 17, 2019


Try cleaning the detergent draw somtimes this can cause water to spill out and ofcourse check the filter and exit pipe :)

Hope this helps
TalkAppliance.co.uk

Bosch Washing... | Answered on Jan 11, 2019


Absolutely those dryer sheets are the root of all evil....I would also recommend a good vent brush to clean your dryer vent.
Follow these steps, it worked for me:
1. use a shop vacuum to clean out the dry vent or a vent brush.
2. Clean your lint filter with windex, hot water and and soft bristle brush.
If this doesnt work try running the until disconnected from the vent for a cycle to isolate the vent as your issue.

Cheers!

Bosch 3.81 cu ft... | Answered on Jan 07, 2019


Check drain pump for obstructions and operation

Bosch Washing... | Answered on Jan 01, 2019


Have the installer give you the instructions that should have been provided to you at the time of installation.

Bosch Washing... | Answered on Dec 29, 2018


Open the small flap at the front bottom right of the machine. DONT unscrew the circular white knob yet!!! Use the small black hose to drain the machine into a tray, by removing the small cap on the end of the hose. You will have to use a tray, rather than a bowl because the hose is only short, and keep emptying the tray.(put a washing up bowl next to the machine, so you don't have to carry the tray.) If water does not come out of the hose, then gently unblock it with a piece of wire or fine knitting needle. When water finally stops coming out of the hose, it is time to gently unscrew the white knob anti-clockwise, and pull it forwards. Now you can clear the debris out of the pump rotor, which is behind the white knob. Check with your finger that it can rotate freely, then replace the white knob firmly. Make sure the small cap is replaced on the end of the hose, clip it back into place and put back the cover panel. If this doesn't work then there is a blockage deeper in the machine, and dismantling will be required. Good Luck!!

Bosch Logixx WFT... | Answered on Dec 27, 2018


check how hot the motor gets after a spin cycle its sounds like a faulty motor

Bosch Washing... | Answered on Dec 22, 2018

Not finding what you are looking for?
Bosch Logo

7,431 questions posted

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Carmen Mikulic

Level 2 Expert

415 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...