Binks Air Tools & Compressors - Recent Questions, Troubleshooting & Support

https://www.about-air-compressors.com/binks-air-compressors/

Does anyone answer you? I put a pressure regulator with manometer to my binks Compressor and the max is 20 psi.

trigger has solid particles behind trigger. carefully disassemble trigger and blow out debris Be gentle with tiny O-rings as they will disintegrate before your eyes, rinse all parts and reassemble. good luck

https://www.manualslib.com/

Man ur needle is worn or bad altogether...look on the back of the fluid needle, might be adjustable...if so, roll the nut FORWARD about a whole turn. If not adjustable...

http://www.bedfordprecision.com/Html_Refs/BedfordQuickRef_Binks_Model_18_Spray_Gun.html Contact parts vendor to requestion information.

Contact a vendor to ask if they can provide a manual. http://www.bedfordprecision.com/contact.htm http://www.bedfordprecision.com/Html_Refs/BedfordQuickRef_Binks_Humdinger.html Bedford Precision Parts Corp Company contacts for paint spray equipment...

Ball park rule of thumb,
Fan Energy 1000-1500 CFM/hp

stopper seal for the trigger is inoperative replace it

this can be contributed to the seals around the needle part of the trigger operation they get hard and don't seal properly check gland seal nut for adjustment to place tension on the gland to make it seal make sure that air bleed hole in the lid is clear and not blocking off

take and screw out your top knob which is your fan control and clean it and also make sure none of the rubbers and seals are cracked, it might be possibly out of adj, but probably just dirty with old paint, clean it out really well with pipe cleaners or brush with paint laquer thinner