Aprilaire Humidifiers - Recent Questions, Troubleshooting & Support
Aprilaire 700 leaks water from bottom of case
Install new water panels yearly. On the new panel make sure that the painted dot on the edge of the panel is on the top when you install it.
Always clean the distribution tray and the frame. Make sure the notch on the edge of the distribution tray faces away from the furnace. Make sure the humidifier was installed level. Keep the drain tube opening clear. Insure there is no blockages in the drain tube.
Good luck
HVAC Teacher
Aprilaire 760 keeps running
Is this a newly installed unit it sounds as if there's a wiring issue. Could you show a picture of the wiring terminals. If this is not a new install try turning of your furnace fan.
Loud "Glonk" when humidifier turns off
Try turning the water valve going to the soleniod down. There may be too much pressure. You may have to replace solenoid one more time after making the adjustment.
I purchased a home with
Here is a link to the owners manual. http://www.aprilaire.com/themes/aa/en/manuals/Humidifiers_Owners_Manual.pdf
You can also pickup some cheap humidity gauges at a hardware store to check the settings on your unit verses the actual humidity in the house.
11/4/2021 12:33:48 PM •
Aprilaire...
•
Answered
on Nov 04, 2021
Our house is extremely humid and the a/c needs to
Hello
It depends on personal preferance,an air conditionner is going to remove humidity or water from the home,as water contains heat.
I would shut off the humidifier.The 40% setting depends on where in the world your located,say nevada is dry and hot so you may want a humidifier.Where florida is hot and humid so you would want to dehumidify or get rid of the humidity.
Lower the setting to 20% or just turn it off.
I have a aprilaire thermostat 8346 is is flashing 11? it does not seem to be working?
With many Aprilaire thermostats, the flashing 11 indicates that there is a broken wire between the thermostat and the HVAC system. You should turn off the power to the HVAC system. Then take the thermostat off the faceplate. Check for any damaged wires. If there is a break near the thermostat, take the undamaged section of wire and secure it in the correct spot. See
https://www.manualslib.com/manual/8847/Aprilaire-8346.html for the installation directions.
You could also try installing a new thermostat. Then make sure that all of the wires are properly connected to the terminals. You may need to check the wires at the HVAC control board or in your wall. You may want a professional to check the system for either of these steps.
I hope this helps.
Cindy Wells
8/26/2018 9:58:51 PM •
Aprilaire...
•
Answered
on Aug 26, 2018
Not finding what you are looking for?