AEG Washing Machines - Page 7 - Recent Questions, Troubleshooting & Support

I suggest trying this link. They will help you online.

https://www.justanswer.com/uk-appliance/23fl9-aeg-lavamat-74800-error-50-reported.html

C0 is Communication Error When no data can be received between input module and main PCB after 10 attempts Check th Communiation cable and port on PLC AEG Favorit 80800 Service Manual Fault Codes

most likely a blocked or faulty drain pump

most common problem is a water valve, as long as you have the tap turned on, many people have forgotten to turn it on

Alarms EH1-EH2-EH3: In the event of problems with the power supply, the appliance remains in alarm mode until the voltage and frequency are restored to within the normal limits or the appliance is switched off. Alarm family "H" is displayed and it is not possible to access diagnostic mode nor to use the "rapid alarm display" function. The complete alarm can be read only when the abnormal condition has terminated. Dado

Run your hand round the inner drum and look for sharp edges, also overloading causes torn clothing

Instructions manuals for AEG LAVAMAT C0461

Pull front nozzle downward and at the same time pull the drill bit out i take this is sds type of drill try it.

Wonderful question!

Hi,

E60 error code is a heating problem.
What you need to do is take the back cover off and from there you will see the heater in the back of the drum at the bottom.
Make sure the wires are still in place on the heater. If they are then you will need a multimeter and meter the heater out. It should read about 28 ohms. If faulty then it will need to be replaced.
If the heater and the wiring check out OK then its probably the control board that's the problem here i am afraid.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!