AEG Washing Machines - Page 6 - Recent Questions, Troubleshooting & Support
My washer is not spinning
Check the brushes on the motor. They should be at least 15mm long. Remove back panel, and remove motor (watch the wiring orientation). Then remove the brushes. If they need replacing get new ones and then blow out the entire motor from the carbon dust created by the brushes with compressed air.
AEG Lavamat washing macine C9 error code
C9 is a motor fault.
Normally it's worn out carbon brushes so you'll need to check them first.
If worn out or broken, replace them.
Then, you need to erase the code (reset the machine).
To do this, turn the dial to off.
Press and hold together, prewash and soaking buttons.
While holding them, turn the dial 1 click anti clockwise.
Release the buttons.
Turn the dial to off, to any program and back to off.
This should get rid of the C9 code.
It will come back if you don't repair the motor fault.
How do i re set an EFO code on an AEG LAVAMAT
you just need to mop up the water inside the cabinet to allow the float switch in the base to reset.check there is nothing stopping the float returning to the floor. a small leak from the door seal can cause enough of a leak to trip it . clean the door glass and seal to stop this. or change the door seal.
ACCESS TO THE TUB WEIGHT IN AEG LAVAMAT L52600
More likely to be the shock absorbers, the main bearing or the spider (the casting the drum is fitted to that connects to the rear pulley)
To test the shock absorbers open the door and press firmly on the base of the drum then release
If the drum bounces up and down like a weight on an elastic chances are the shock need replacing
To check the spider firmly grasp the drum left and right and try to wobble it
then turn the drum 1/4 turn and do it again.
If there is a noticeable movement in one of those two position the spider is broken
To check the bearing remove the back cover and look for rust stains on the back of the drum. if there is then it will be your bearings
Shocks are a cheap repair, however if the spider or the bearing have failed it my be cheaper to replace the washer
Timer programme
Drain pump may be obstructed or defective. You may have to call your engineer back. Maybe he disrupted something.
My wash-machine, AEG oko lavamat
to clear the error code: whilst holding the pre wash and short wash buttons in together turn the control knob from off to gentle spin, this will clear the fault code and run a LED test. (if all goes weel) F9 means carbon brushes need to be replaced
Not finding what you are looking for?