AEG Washing Machines - Page 3 - Recent Questions, Troubleshooting & Support
AEG oko-lavamat 72630 update
It is a communication problem between the circuit boards inside the machine. It might be as simple as unplugging and replacing the wires, or you may indeed require a new circuit board.
Where do I find the 4 diget code to AEG BPE742220B Ovn
If there is a fault happend the error code should appear on the display (as shown picture below) :
There are two types of error code, first one that begins with a letter "C" and a mean customer fault code that can eliminate by the customer.
for example:
C1 - means "Telescopic runner inside during pyrolyse"
Remedy: "Remove side grids during pyrolyse"
Faults that begin with letter "F" require the expertise of a service technician especially when it comes to new ovens powered and controlled by electronics.
for example:
F 239 means: Quantum Touch Controller alarm:
1. If the communication over the bus SPI with the Quantum touch is after 50 trials unsuccessful than alarm is set. The alarm is reset if the communication is okay again.
Could be:
1. Connections Board Touch.
2. Board Touch fault.
Dado
Error9 what does this mean
turn Programswitch to ‘OFF’ -
press first 2 buttons (1 and 2) Keep it pressed turn programswitch 1 klik to the left (against the klok)
all LED’s lights up.
realise the buttons
turn progam switch to off
youre machine is now reset
if problem comes back, carbon brusches on the motor are defect.
Not finding what you are looking for?