...Y1 and Y2 the table only displays X and Y1, not Y2. I can only highlight the y1 = sign or the Y2 = sign, but not both. any suggestion to correct this? thanks I have had the same problem luckily i ...
Question about TI-84 Plus Silver Edition Graphic Calculator
...is a single stage system, look for the y1 and y2 terminals. If the thermostat does not have y1 and y2 then you may have the wrong thermostat. As always, please read the directions carefully.
Question about TI-84 Plus Silver Edition Graphic Calculator
...y2-y1)squared. Save this into memory 'A'. Now do the same for x2,y2 to x3,y3 and add this to the number saved in 'A' and do it once more for x3, y3 to x1, y1 and add to the number in 'A' to get the ...
Question about CFX-9850G Plus Calculator
...values, equal and opposite to those of Y1. In that range, Y1 and Y2 are symetric of each other with respect to the X axis. For positive values of the x-variable, Y1 and Y2 are identical. Hope it ...
Question about TI-84 Plus Silver Edition Graphic Calculator
...y1 & y2 Hello, Sure you can. Values of Y1 and Y2 will be calculated for the same value of the independent variable. here is a screen capture taken with NO special configuration. Functions ...
Question about TI-84 Plus Silver Edition Graphic Calculator
...to Y2 on the air handler and probably does not continue out to the condenser. The Y2 should be going to the contacor that brings on your backup heat. It seems like Y1 and Y2 are reversed
...Y1 and Y2 In your mind decide which one represents f(x) and which represents g(x), probably f(x)=Y1(x) and g(x)= Y2(x) Validate each one by pressing [ENTER] Do not worry about graphing the function. ...
...y2-y1)/(x2-x1) 2. Replace the calculated value of a in the equation and write that one of the points ( P1(x1,y1) for example) satisfies the equation. In other words y1=a*x1 PLUS b. Here y1 and x1 are ...
...y1'(x)=y2(x), y2'(x)=-y1(x) for initial conditions y1(0)=0, y2(0)=-1.Finally, x axes=y1(x) and y axes=y2(x) I checked the manual and could not find an error message invalid Axis. I did find ...
...a vertical line so the slope is infinite. The slope of a line through 5 -5 and 5 0 (x1,y1) (x2,y2) Slope = (y2 - y1)/(x2-x1) = (0-(-5))/(5-5) = 5/0 Any number divided by 0 is undefined. Good luck, ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions