...torque specs for your vehicle Parts Exhaust flange nuts and bolts Head Gasket (preferably OEM) Ten head bolts Two valve cover end seals Tube of RTV silicone Disassembly 1. Disconnect the battery ...
...front wheel and splash shield NOTE: Place a 1 in. x 1 in. x 2 in. long block of wood between the torque strut and cradle to ease removal and installation of the torque engine mount. 3 right side ...
...motor down to the block, and replacing every gasket in your way down, as well as the head bolts (torque-to-yield). the way the saturn timing components are ran i would not suggest this unless you ...
why do i have oil in my radiator Sounds like your head gasket is leaking. If the head is not warped, replace head gasket and torque to manu. specs.
looking for head bolt torque for 95 SOC saturn. im having valve guides replaced The torque spec are as follows, step one is 22 ftlbs then step 2 is 33ftlbs and the third step is to tighten bolts ...
i was wondering if anyone could tell me the torque specs on the valve cover on a 97 saturn with a 1.9L dual overhead cam 120 inch/lb (10 ft/lb.) out of my field service manual
specs for a 94 saturn sohc Hello jakeslonewo, I just did one of these today and the procedure is as follows. If you are using new head bolts (Recommended) install the head and toque the bolts to 48 ft
...torque specs for a 1996 saturn sl Quote: Originally Posted by norvelplagbao52 1993 saturn sl2 1.9 dohc cylinder head torque specs and sequence Cylinder head bolt tightening procedure: CYLINDER HEAD ...
Question about 1999 SL
Looking for torque spec for front wheel bearing on a Saturn sl1 1999 Looking at different sites and read between 75inch pounds to135 foot pounds 148 ft lbs
Question about 1994 Sl
What are the torque spec a 1994 saturnsl1 for the rocker arm assably From what I can find it is 19 foot lbs for the rocker arm shaft.
Usually answered in minutes!
1,310 Questions
953 Questions
963 Questions
862 Questions
606 Questions