Questions & Answers for: Chrysler Sebring torque spec s

2000 sebring transmission pan torque spec need torque specs for 2000 Sebring jxi convertible, transmission pan torque specs and bolt tighting pattern? 10 ft lbs no real patterm needed

need torque spec for starter mounting bolts 1998 sebring coupe 2.5l, vin"n" TIMING BELT FORD ESCORD 2.0 40 ft lb torque .

torque spec just make sure the bolts are tight when you put it back in and dont overtighten these bolts.the new unit may also come with the torque spec as i stated before. I believe this is a chrysler

...Convertible Limited with 3.5L V-6 and Aluminum Wheels. Thanks for asking.... most people just use the German torque spec..... "Gut-n-Tight" 100 ft-lbs and then Re-Check torque after 50 miles!!! ...

need the torque specs for the upper intake bults on a 2002 chrysler sebring conv. 2.7L Fig. Intake manifold bolt torque sequence 2.7L engine Upper intake manifold with a new gasket on the lower intake

I need the torque specs. for a 2002 Chrysler Sebring conv. I had to replace the engine so I need all of them. Thanks. What engine size, 2.7L or 3.0L, and torque about what component (cylinder head, ...

I need the head torque order and the torque specs, for a 98 Chrysler Sebring with a 2.5 ltr. CYLINDER HEAD TORQUE/SEQUENCE: Use the special tool and a torque wrench to tighten the bolts to 103 - 113 ...

i need the head bolt torque specs for a 1999 chrysler sebring' CYLINDER HEAD BOLT TORQUE Use a torque wrench to tighten the bolts to 76 - 83 ft. lbsof torque in the order shownTightening should be

torque specs for rod bearings on 2001 chrsler sebring 2.7 Go to your local library and see if they carry Chilton's manuals for car repair. Usually many of them do and you can find your specs there

I need the cam gear torque specs and the timing belt marks 1999 Sebring Convetible JXi https://www.youtube.com/watch?v=uVg4cQdcn80 ...