...from first gear 1990 chev truck automatic. won't change from first gear. when idling i can hear the torque converter roaring. goes in first gear fine but won't change to 2,3 or 4th. could it be my ...
...nut off,if you are talkin about the lug nuts then they are 7/8" standard or 22mm metric,and the torque on those are 140 ft lbs.the rotor might just be rusted on,a good whack with a hammer after ...
trouble disconnecting upper engine oil cooler line at filter housing. Replaced line earlier by snapping tips off old brittle connector but appears I left out a plastic seal as it poured oil after 5 ...
Question about 1990 K2500
...problem? After 8 years, you put in a fresh engine but do not touch the transmission, at least the torque converter? Seriously, hindsight is great, isn't it! Well, you got my take on it. I think you ...
When in reverse the trany shutters slightly. Is it serious? definately something to worry about: torque converter, trans filter, U-joint(s), or your rear gears r going out
what is the lug nut torque for a 1996 Chevy K2500 with eight lug hubs and standard steel wheels? It should be 100 ft. pounds.
whats the stall rate for a torque convertor for a 1990 chevy k2500 Hi. Good question as many stall are about 3000+ RPM. GM used many different speeds and the one associated with your particular truck ...
what is the torque spec Torque spec for what? There are torque specs for every bolt in the engine.
...driven about 10-25 miles,or when it gets warmed up.I am told it is getting to much pressure to the torque converter.The valve body was "repaired" by a dealer. Now they want to put a new
Question about 1990 K2500
what are the torque specs for a aluminum water pump on a 2004 chevy silverado 6.0 They need to be done in 2 stages the pass needs to be set on 11 ft.lbs. then the second pass needs to be set on 22 ...
Usually answered in minutes!
83 Questions
77 Questions
64 Questions
39 Questions
45 Questions
