I need the torque specs and sequence on a 1998 chevy 350 vortec I had to change the head gaskets in a 1998 3/4 ton chevy with a 350 vortec in it. I need the torque specs and sequence so I can put it ...
need 8.1L torque specs to do a head job So you understand, GM uses a torque angle meter in their torque sequence. It is as follows:
need bolt torqe specs , rods, mains, oil pump & oil pan for 6.0 vortec engine thanks Connecting Rods: First pass 15 lb ft. If you have an early first design final pass 60 degrees. Second design 75
torgue spec for the pitman arm nut 180 ft pounds.
would it be worth it my wheel bearing is going out and i think the kit comes with them as an adapter kit 375 bearing 250 Im not sure exactly what your question is but it is worth it to replace the ...
...Check your fuel pressure it should be 9-13 psi with key on and engine off.If its not within these specs then replace the fuel pump and filter. Hi, Try holding the pedal to the floor when you crank ...
Question about 1998 C2500
...1998 2.6? What more info do you need if you just put a head gasket on there it came with torque specs most do.. if not call the parts
...5.7 ENGINE INTAKE MANIFOLD TORQUE SPEC INTAKE MANIFOLD TORQUE SPEC Anon, call the dealer to verify specs. below, as some times there are changes/new specs. updated because of issues. On 5.7L
Usually answered in minutes!
82 Questions
54 Questions
42 Questions
37 Questions
36 Questions