Questions & Answers for: Mazda 626 ignition coil

...ignition coil... ignition module.... plugs are getting barely any spark. while driving the car completely shut down. we replaced the coil and it ran for about 5 miles and then shut down again. so we ...

...ignition coil power source...get a test light & check for power with the key on @ the positive side of the coil...if it does have power have a friend crank the engine over & check the negative side ...

...ignition coil? Does the coil meet the ohm ratings for that years vehicle ignition? Does the vehicle have oil in it so the oil pressure sensor allows the engine to run, this may not be an option on ...

ignition coil and ignition control module part of the distributor? Hi, common thing with the mazda was the coil or the ignition amplifier going faulty, both of which are located within the distributor

...the ignition coil Iginita, Knock control, distributor, cable and plugs. Do you have spark? Do you have fuel ? If tachometer shorted the car will not spark even if 12 V is present at the ignition

ignition coil electrical connector but not sure what leads to connect to. Wires are red/black, green, yellow inside this connector. On an older car from 60-70's, I would think coil was gone and needed

...ignition coil @ on a 96 mazda 626,4 cyl.? 96 mazda 626 4cly. was driven and started to miss alittle,and cuts off. wouldnt start bac up till next morning, no engine light has came on yet. im thiking ...

...ignition coil module on a 1994 Mazda 626 The ignition module is integrated within the ignition coil itself, and the only repair possible is to replace the entire coil assembly. There are six ignition ...

...ignition coil . 4) A bad rotor or distributor cap (cracks or carbon tracks that are allowing the spark to short to ground). 5) Faulty ignition switch. ------------ You can also do a test to confirm ...

...ignition coil. Is an ignition coil and pickup coil the same thing? no its diffrent. ignition coil drives the spark plugs. pick up coil produces the pulses needed for the ecu, to drive the ignition ...