Questions & Answers for: error code f1 amana ptac

...error code in the manual. I do see nP as an error code for Window Switch lockout. I just had this happen to me and they had me reset the control board. Remove case, flick master switch to OFF for 10 ...

...Amana Ptac Model # PTH123A25AB. It is showing F1 on the display. How do I get it working again? Evedently F1 is an indoor thermistor problem. This is the sensor that is at the indoor coil. Normally a ...

Error code C7..amana ptac 2012 r410a runs compressor 5-10 min then will not run only fan. freon level is good. reset and compressor will run again then only fan again..cleaned That means evaporator ...

...error code Br on my Amana PTAC was fixed by resetting the unit. It worked fine for a day then stopped again. This time resetting has not helped. I have checked the voltage from the outlet is 250 bad ...

What does the error code F1 mean on an Amana PTAC under window unit? either bad heater element or ignitor

...error code on Amana ptac unit F1 - Control Board Failure - Replace control board (ERC). F2 - Oven Temperature Too Hot - Replace oven temperature sensor. F3 / F4 - Shorted or Open OvenTemperature ...

...error code flashes, but I did notice on my configuration the C5 tell the temperature but also flashes 09? What could be the problem? Hydronic switch open 9 E9 Hydronic switch open (if hydronic ...

...otherwise is dead. Control board will not light up. I have 6 PTAC's like this. What is Causing this? Maybe something here will help you....

Amana PTAC air conditioner. Switch to a wall thermostat? Question edited for clarity and toss in some CAPS. You can get wired or wireless. https://www.amana-ptac.com/products/ptac Fitting ...

...Amana PTAC https://www.amana-ptac.com > products > ptac Looking to buy an energy-efficient PTAC unit for your building? Buy the new Amana R-410A PTAC unit heat pump, which reduces energy consumption ...