My Windchaser ICM12 will not work. The cube size indicator blinks constantly. unplugging the unit to reset does nothing. What is wrong?

I noticed with this unit you have to remove the water inlet tubing unplug the Low water sensor get some works bathroom toilet cleaner and put it in holding the lowest tubes closed let it work for 1 min then thoroughly wash it inside only and reinstall it the low water sensor has issues with build up causing this unit to stop working after you reinstall it stand the unit upright for 24 hours plug in and set cube size then it should start working like new

To adjust the cube size raise or lower the float located to the left of the pump, raising it higher will reduce the size lowering it will increase the size.

This error means some thing is wrong with the fan to the ice maker. It might also be a bad control board. If it is still under warranty get he board replaced. Kenmore has had some problems with these particular boards. You make be able to reset board by unplugging unit for a while and plugging it back in. Hope this helps

Reset the circuit breaker. It too maybe a GFI circuit.

Thank you for being very descriptive. I would get the installer back out since it is new and probably still under warranty and instruct them to say with it until it has satisfactorily run a couple of cycles. They can easily troubleshoot this machine while they are on the job.

Believe it or not, this link has the ICM15 manual. Now if I can just get my
dump tray to rotate before the cubes all freeze together ...

Download this manual there is a toll free number on the front cover.

http://www.yachtsofstuff.com/adgraf/MermaidMFG/Portable_ice_manual.pdf

look for the manual its usually underneath...remove the grille and look inside. sometimes its taped up

i can help you troubleshoot if you find!

There is an adjustment, but first check your filters, including the one in the inlet of the control valve. To find the adjustment, take the cover off the front of the ice maker. On the side may be a little hole. Look for any 'increase' arrow or such. If not, use a small screwdriver to turn the adjustment a half turn and let it make a load of ice. If it gets smaller, go the other way, use small adjustments. If you can get the owner's manual, it will help a lot. Google your unit for one, you may be able to get it downloaded free from Whirlpool.

When changing the battery it should be a alakline. Also try unplugging the unit and then back in again. Check to see if the sides are getting warm which will indicate the compressor is running. Make sure the compressor is running. Check to see if thermostat is up high enough. The unit may have an electronic board that may be the problem. And lastly, it could have a sealed system problem, like a freon leak. You didn't say how old the unit is.