The timer light is flashing and I can't figure out how to reset the unit via the remote. Unit now only produces fan air. No cold air. Thanks/Aloha, Jim
james.rollison@navy.,mil
I had a similar problem with only fan air then the blinking lights, found out that mice had got into the circuit board and corroded some connections with their urine. I would try the above solution by turning the power off for ten sec first but remember that you have to leave it for a few minutes before you operate remote.
Blinking led in the unit means some error or defect in the unit. It
stops the remote control from working to protect the unit from
operating with defective parts to avoid severe damage to the unit.
Try to reset the unit by disconnecting the power supply for 10sec. then
on the power supply again and test. If it wont work then there are some
defective parts in the unit that need to replace.
I have a 220v system and I had the same problem when we used a 110v line by accident. Once we ran the proper voltage it started up fine.
1,634 views
Usually answered in minutes!
i have the same problem
I have the same problem too. The timer light flashes in sets of three blinks, no cold air comes out
i have a same problem, after my 3 weeks holiday my aircon doesnt work, the green light for timer is flashing together w/ red led light. no fan even the outside.. i think its a timer problem..
Timer light is blinking, indoor fan is operating but outdoor unit will not run. Just installed today.
×