My samsung SCX-4623FN printer interrupts printer jobs and prints out error page that says: INTERNAL ERROR - Incomplete Session by time out POSITION: 0x9791c (620828) (numbers here are different every time) SYSTEM: h6fw_5.35/os_hook LINE: 1224 VERSION: SPL 5.35 06-03-2009 and another problem. after replasing toner that came with printer (1000 pages capacity) with samsung 1052L toner (i think it's supposed to print out 3000 pages) it printed ~1000 pages and started interupting print jobs and asking to replace tones becouse its low, but i click continiue printing and it prints just fine (disabling low toner warning didn't solve this)

replace drivers

mi impresora se bloquea a penas doy la opcion de imprimir funciona y cuando supuestamente va a coger la hoja queda bloqueda ssale q es error #04-002 no se q hacerl ya le revise y no tiene atasco de hojas ni nada q debo hacer si solo dece q la apague y la vuelva a prender pero no funciona

If every thing is setup as DHCP, look at the routers log and see what Address the printer is on. Then bring up the printer properties and check the port settings. If all is correct, remove the printer and reinstall the driver.

The Samsung CLP 770 produces an 'incomplete session by time out' if you switch off the computer originating the print in the middle of the print job (before the print is finished) OR if the network connection is lost between the computer originating the print and the CLP 770.
The printer may have printed the start of the print job but also recognises that it has not received the end of the print job information. It waits for a good while for the connection to be restored in an attempt to receive the rest of the print job - but if nothing comes then it times out.
The reason for this action is to prevent this situation effectively locking out any other computer on the network from printing while it 'waits' for the end of the print job.

Hi,

There could be few reasons for this. One of then is the Printer Spooler that much be corrupted and another would be the actual printer printing drivers

Click on START button and Click on Run
Type the word CMD ( or COMMAND ) and hit enter key
You will find a new black window on screen.
Execute the following commands,
net start spooler ( hit enter key )
net stop spooler ( hit enter key )

follow the same Start and stop command for 4-5 times. End the Command with NET START SPOOLER ( hit enter key )

Disconnect the Printer USB Cable and re-connect.

It should start printing.

Hi
you need to replace motherboard
the cost of it is to high
you better replace your printer

Pls vote us to keep us alive

Good day Sir, These are the possible causes why your machine print the wrong text.

Problem: The machine prints, but the text is wrong, garbled, or incomplete.

• The printer cable is loose or defective.
• the wrong printer driver was selected.
• The software application is malfunctioning.
• The operating system is malfunctioning.

Have a nice day!

djsizzler26SImple Solution..Just Connect ur printer with external USB hub

the doctor blade in the cartridge tobe replaced.