When I sit on bike and pedel bike will no go pedels seem like there stripped just spin something wrong with pedel bearing maybe

if your machine has this slide button on the motor casing maybe you need to switch it back and forth a couple of times

It's the clutch bearing in the brake assembly. They can be replaced but you would need a bearing press. Might be better off buying a new assy.

id say Hill's is number one on my list . then they go down in importance - gears- brakes- bearings- oil loss

Hi Kim:
Since this is a new bike I would not waste any time trying to find out what is wrong.
I would take it back to the dealer or store where it was purchased and ask for a replacement.

well i have one ideal on the brake pedal there should be a spring to make the pedal return.......maybe the spring needs a bit of wd40 or something similar.....if you get any dirt or grit in the brake pedel works may this is causing the trouble..........

Your losing fluid somewhere, it is a hydraulic clutch so this means hydraulic fluid powers it. Bring to transmission shop for repair.

If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

There is a button above your brake pedel that probably isn't being pushed in all the way by the brake pedel to shut them off. Try pulling up on the brake pedel and have someone watch to see if they go off when you do that. If so the button for the brake pedel needs to be adjusted so it shut them off when the pedel is not pushed.

Could have sticky or seized up crank bearings where the pedals are or the rear wheel bearings. Have you tried pedaling and spraying a lubricant where all the bearings are or remove and re-grease the bearings?

You don't identify the bike so generic is the best I can do...

http://www.sheldonbrown.com/gears.html

http://www.jimlangley.net/crank/bikingskills.html

if you mean the clutch doesnt engage until the pedel is nearly all the way out (up) .. then there is an adjustment for that called "free pedel adjustment" .. its usually a 5 min job .. however if there is any clutch chatter or noise then you may need a new clutch plate ... a bigger job ... one way to burn up the clutch plate is to allow it to slip for a long time ... and thats what will happen if the free pedel adjustment isnt done soon ... if your problem is not that then maybe you can expain more ....