Water leaks in all programs - Bosch WET 2820 Front Load Washer / Dryer

Keurig has a good warranty program. I would return it and get a new one.

BAD WATER INLET VALVE

Look for leaks, it must be going somewhere.

There is a tool called a radiator pressure tester. You can borrow it from Tool loaner programs like at Autozone. Do not exceed the pressure on the cap and do this test on a cool motor. It will help.

If you still can not see the leak, there are dye additives to add to the water. Look on the ground for escaping water.

The problem may be internal if you do not have an external leak.

Failure of the main door gasket which might need a replacement.
Secondly the program is not being controlled and so there can be an inlet valve failure resulting in water building up even after the program is stopped.
So have these tips checked to confirm.

This seems to be that the Anti Flood system has triggered. This device detects water leaks / spills to the bottom of the washer and automatically puts the washer in pump out mode and shuts off the water inlet. The device is made up of a pollystireene float and micro switch that activates once the float detects any leaks / spillage. Dry water and check for leaks and this should solve the problem

Hi,
Here is a tip that will help you with that problem...

My Steam Iron is Leaking Water
http://www.fixya.com/support/r5301301-steam_iron_leaking_water

heatman101

This is caused by the water level switch not working correctly. This is most commonly caused by the internal filter being blocked, you need to remove the filter and clean out all the buttons coins and lables ETC , see the note on how to do this from other user

Sound like some water or detergent is being directed up instead of down into the tub and eventually leaks out when you open the lid. You need to check, maybe using the Service Program, to see how it fills and how the detergent comes out.

Most common reason is that the lower spray arm splits on the seem and sprays water under the door, to proove if it is this remove lower spray arm and run through program if no leak fit new arm. Regards Advisor