Code E4 on dandy wine cooler mod # dwc283bls - Danby DWC283BLS Wine Cooler

try there http://www.searspartsdirect.com/partsdirect/part-model/Danby-Parts/Wine-beverage-cooler-Parts/Model-DWC283BLS/3055/0169000/50031952/00001?blt=06&prst=0&shdMod=DWC283BLS

http://www.searspartsdirect.com/partsdirect/part-model/Danby-Parts/Wine-beverage-cooler-Parts/Model-DWC283BLS/3055/0169000?pathTaken=&prst=0&shdMod=DWC283BLS

Hi,

I am sorry to hear regarding the trouble. This is a common problem on this unit. E4 refers to a faulty control board failure. Unplug the unit for few minutes, say 15 minutes and then turn it on. If this would not reset the error code, the only solution is to replace the board.

I wish i could have a better solution.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

go at sears go to this address http://www.searspartsdirect.com/partsdirect/index.action?pop=flush
and good luck with the repair

good morning. according to mark rydal the director of dandy inc (publish ny times 22sept 208) there were faulty compressor electrodes fitted to the 283-3400 series yet there is no advice on the fix as a tech i beleve the cause is faulty sensors in the pcb but to date all the paper work i can find on these problems has the owners binning them after having them repaired as the fault re occurs over and over


hope this helps

merry christmas

wine coolers have no means of draining the condensate inside them,use silica gel(1/2 pint)to keep the inside dry(remember to dry it out when condensate happens again)

Disconnect the power cord from the wall outlet and wait 30 minutes before pluging back in. This should clear all settings on the cooler.

http://www.danby.ca/cms/uploads/products/en_manual/DWC283BLS.pdf

Dear moriquenda
welcome to fixya.
Did you try resetting the system by pulling the plug and waiting 5 minutes then restarting the wine cooler?This may solve you problem.

Danby expects customers to call service and does not imagine the rest of the world being able to utilize these codes.
Closed minded, Huh?

Please remember to leave a rating!
Huuum

temperature sensor open

Is the compressor running? I don't know this unit, but know that if you are too warm that is the first thing to check. In reading about another unit that had a different problem, it was mentioned that there is a ciruit board. If it has relays on it then these are the most likely culprit. They are either not making contact or staying in contact too long... sometimes just tapping each relay usually a black plastic component will cause it to work intermittently..Not sure if you can get these but call the company help line at 1-800-263-2629.