I have 4 TVs using 2 receivers. TV 1 and 2 use receiver VIP722K. TV 3 and 4 used receiver 322G. I bought a new Vizio tv to replace TV 4. (Note: TV 2 is also a Vizio) I tried to set up the new Vizio and the remote using the programming codes availalble. The remote reacted like it was coded properly. However, it somehow has coded to TV 2 instead of TV 4. When I turn on the new Vizio, the screen says to press SELECT on the remote to continue. But when I press SELECT, nothing happens, like it is not responding to the satellite. I can take that same remote into the room for TV 2 and it all works. How do I get the remote for TV 4 to respond and use receiver 322G?

Hi, Cheri Torres with DISH Network Customer Service here. Icame across your question and wanted to see if I could help. It sounds like youmay need to either readdress your TV4 remote to your 322 DISH receiver or youcould possibly have receivers for TV2 and TV4 mixed up. Since your TV4 has "Pressselect to watch TV" on the screen you can check both of your receivers andwhich ever receiver has the TV2 blue light off is the receiver this TV runs offof. If this is not the case and you are positive that the TV4 does run off the322 you will want to take the remote to the receiver box location in order toreaddress it. I will list here for you the instructions for readdressing theremote to the receiver box. I hope you find all this information useful and ifyou have any other questions or this does not fix the issue you are experiencingfeel free to email me at [email protected]. Thanks and have a greatday!
Instructions for readdressing your remote to your DISH receiver

1. Go to System Info screen. You can do this by pressing the power button once then the channel up button once on the front of the receiver box.
2. Once you are in the system info screen you will see primary remote address and secondary remote address.
   
3. Hold down the SAT button until all mode lights light up.
4. Enter a number between 1 and 15 using the numeric keypad on the remote.Change the number to something different then what is already listed in the little white square for secondary remote address.
   
5. Press the pound (#) button
6. Once the SAT button blinks three times, press record. Note: If successful the number selected in step 4 will appear in the System Info screen under Remote Address.