Hi. I have a Godrej make e-swipe safe (locker). It has been functioning alright. But recently even after correctly giving the 4 digit password, the display says 'OPEN' and after 3 secs 4or5 beeps given and a message "Error-1" appears on the display. I tried the manual override by using the Key provided. But it doesnot open. I even tried giving wrong passwords and then also it says "Hold-15" and no use thereafter. Kindly help me out in opening my safe locker. Thanks in advance..... Rajan

The password is set by the owner of the safe.

4wd or NOT, 2wd, but 4wd both ends match.
well , not wanting to pulled cover off and have GL5 lube all over
or #2 googling for all Jeep axle codes. (your call)
there is no CHEVY RPO code build list\
#3you call jeep dealer give VIN and he tells build list to you.

or the tests. #4
put car in 2wd, but one rear tire on ICE or wet grass
then move forward quick. (gas pedal

if both tires spin car moves is Positration clutch packed rear gear set.(or lockers of many kinds)
if limited slip 4 gears only then one tire on grass /ice only spins fast and car does not.
there answered all 4 ways.

ok way #5, rear tires off ground both, ON JACKS STAnds safe.
in neutral 4wd box or. if not 4wd tranny in neutral.
hand spin 1 tire and both turn same direction for locker.
if it 1 spins backwards the axle is open (limited slip)
open is 4 gears (side+ spider)
Lockers have a locker or clutch pack just like seen in the A./T BOX.

lockers have vast names. but all lock up some way.
open axles means sans/locks.
I love lockers. saved my bacon vast times. even pulling super heavy boats out of the ramp, and zero slip. 2 tires spin is JOY.
even 2wd drive with a locker is a joy. on snow and ice too.
1 wheel drive is for squids.

there's a website reliable-store
all heavy equipment repair issues servicing, loading, wiring, engine problems everythi ng is covered here its a must try

Press CLEAR(*) key twice, display will show “PROG”, then enter original master code (factory preset is 800000), display will show “NEU”. 3. Enter the new 6 digit code of your choice , the LED display shows “AGAIN”, then enter the code again and press LOCK(#) key to confirm. 4.

Hi,

Follow this link:
https://www.youtube.com/watch?v=E7nWCVN2aME
In the comments you will find that some time ago default password was 2125. If it won't work then movie will show you other method.

Best regards

Is the battery dead?
Has someone tried to get into the safe causing the keypad to "freeze"?
Have you tried the "Emergency Manual Override" also know as the key? I hope the Emergency Manual Override Activation Device (the key) is not stored inside the safe.

I'm facing the same problem, Any solution ??

for folder locker use this free software

www.newsoftwares.net/folderlock


and recovering of email id password is given by the host of ur email id like gmail .. yahoo etc


for recovering pass of folder :

u know most of softwares use multiple method to recover password .

for longer password a lot of time will be taken(upto 1000's years) so forget about this ...

i've tried a lot but i cant get even a 4 digit password recover even by using commercial products..

hope u like my post .. so plz rate it... thanx..

i have godrej electronic safe. i m forgot my password. and key is inside it. Is it possible to open.