Samsung manuel for SCX-4623 - Office Equipment & Supplies

You are need to removal the covers and verify or change the microintrerupter.

This is common. Check the right side of the front door. It will not be flush with the main case. Just give it a wack. it will work then.

Dear
The front door right side there is a lever found when it is opened the lever should close the micro switch inside and the door is locked with another short lock (near the long lever). If door lock broken then the micro switch push the lever and door not closed.

the basic problem with the micro switch and related mechanical alignment.
Thanks.

If you are getting lines on the faxes you send it means that the glass of the scanner is dirty. Best method to clean the glass is rubbing alcohol and a soft cloth. The alcohol will remove adhesives and white out better than glass cleaner. You may need to look closely because a small amount of adhesive will distort the scans and cause lines and may not be obvious unless inspected very carefully.

Dear if you are using smar through 4. scan the image using SCAT TO button-select FOLDER-SCAN-select the folder to save-select the file type to PDF to save-click on SAVE.

Thanks.

PLEASE ENTER THE CONTROLE PANEL - (MENU -# 1934 - MENU)

You can find the manual at
http://www.samsung.com/us/support/owners/product/SCX-4623F/XAA
Please rate this solution. Thanks.

go Support ' Samsung Product Support & Service Solutions.

If any more problem encounter,post or thumbs back.

Reset printer using reset software (permanent solution)
[email protected]

Reset printer using reset software (permanent solution)
[email protected]