How do i put brackets in a problem - Texas Instruments TI-84 Plus Calculator

Question edited for clarity, add maker.
Question moved to model category.

Check out the diagram

https://www.hsfmanual.com/shift_cable_repair_procedures-345.html

and the videos.

https://www.google.com/search?q=2002+Hyundai+Santa+Fe.+Correct+position+for+shifter+cable+bracket

..

Make sure you have the correct bolt holding the calipers and if they are put lock tite on all the bolts

Use 6-point wrenches or sockets to eliminate slip. From your post:

"i went to go drill the bolt out i got it drilled out but i was putting a new bolt in the alternator bracket cracked so i need to know how i can get the ac compressor off..."

I cannot tell whether the bolt cracked or the bracket cracked from your post above.

Do you have any kind of small cut off wheel?

(THIS IS A TWO PERSON JOB)(be sure u unload the door first)At the top of the door u have a bracket with three screws or bolts in it, take out the screws while the other person holds the door once this is done take off top bracket the door should lift off of the bottom bracket,now take the bracket off the bottom of the refrigerator,On the other side of the fridge there should be some small white plastic plugs pull them out ,this is were u will put the bottom bracket ,u will also have some plugs on the top of the fridge too..be sure u put the plugs back in the holes that u just took the screws out of.Put the bottom bracket on first,do not over tighten screws,then take ur door place the bottom of door on bottom bracket,put bracket for top of door in the top and screw back down now ur door should be good make sure it closes correctly,and of course put the stuff back in the fridge

youll have to clamp the brake hose,undo the bleed screw,and push the piston[s] back in,then shut off bleed screw,undo clamp on hose,and try assembly again.bracket first,then pads into bracket,then slide caliper over pads,and then put bolts holding caliper back in ,with a bit of grease on the slides.

remove back, loosen motor bracket, remove belt, put new onw on, belt size on belt, move motor on braket to put tention on belt tighten motor bracket

i had the same problem you have to make sure the motor is supported and then take off the mount from the frame to the motor so the bolt's dont thread wrong from there take off the left bracket below the starter put the belt on not all the way yet put the bracket back on make sure the belt is in the grove it go's in then put the mount back on release the motor slowly and release the tension and put the belt on make sure in the grove's not any over hang make sure follows the map too put the tension back on and wallah all done hope this help's

It is unlikely brackets can be purchased. I found brackets vary between keyboards even on the same model laptop.
Your best bet would be purchase a replacement keyboard.
Check on the Internet for replacement keyboards.
I purchased keyboards from Yall Store for approx. $60
Use this link
www.yallstore.com

the bracket should have instructions. the set will have screw holes on the back to bolt to the bracket.
more detailed info needs to come from the bracket MFG

I have the same one i am looking for the wall brackets, I lost mine. I also bought mine at a garage sale the people had it attached to the wall completely hooked up .they had no fire backer on it .They only took it off the wall when i purchased it