After first wash cycle, machine beeps and we get a

"Sd" - (Excess suds)
F8 followed by E1 - (water supply error)
F9 followed by E1 - (drain pump system error)
F5 followed by E2 - (door will not lock)
F7 followed by E1 - (motor drive error)
"rL" - (remove load)
Washer making error beeps - Door has not been opened and closed for at least 3 cycles
Washer beeps when HOLD TO START is touched - Door not closed
F# E# code other than as described above appears in display - System Code Error
"nt" (interrupted) - Cycle was paused or cancelled
Clean Washer LED flashing at end of wash cycle - The washer has run 30 wash cycles and is indicating a reminder to run the Clean Washer cycle https://removeandreplace.com/2015/05/05/washing-machine-error-codes-front-and-top-load

You need to supply brand and model numbers in the question itself when posting.


https://www.ifixit.com/Answers/View/116311/Why+does+my+washer+stop+half+way+through+cycle

https://diy.stackexchange.com/questions/21181/what-could-cause-my-washing-machine-to-stop-before-the-rinse-cycle

http://www.whitegoodshelp.co.uk/washing-machine-sticks-stops-mid-cycle/

http://appliances.wonderhowto.com/how-to/fix-your-front-load-washer-if-stops-mid-cycle-381047/

control/timer unit fault.

Remove the power for sometime , check if the spindle is FREE and moves. , Remove the back and under side to inspect for any damage to the motor or drive. check the power lines, check on the motor CAPACITOR. Now when powering check the VOLTAGE to the motor. if this is low or absent then the program controller unit is faulty.

my washing machine seems to get through the was cycle with no problems but stops when it gets to the drain or spin cycle. Just continues to beep.

this is a 130 faulty which is a faulty rotory position sensor

The control board has detected an error. Press any button to wake the machine then wait for 5 seconds. Press and hold the START/PAUSE and CANCEL buttons simultaneously then the failure code will appear in the display as an "E" followed by two numbers, a number and a letter or two letters as long as the buttons are held. The control will beep and the Door Lock, Wash, Rinse, and Final Spin indicator lights will flash. Post back the code for further advice.

Out of balance switch could be faulty/ coroded.
have a gw 709 and it had the same problem, out of balance switch had jammed on

I believe there is a setting where you can turn the beeping alarm off completely. Read the manual and you should find it.

No power? Let's see if we can solve this problem.

1. Unplug then plug back again.
2. Start the program.

• If beeping send for repair/replacement.
• If not beeping be happy to continue using your washing machine.