Paper feed and colour problems with Konica Minolta bizhub c250

You can try it, but the manual says 10 at a time via the Bypass tray. The problem is the fact that normal paper from the trays takes a rather tortuous route through the machine that contains sharp turns. By far the easiest way to print a lot of envelopes is to use Avery 8163 Labels. Use the Avery template and create the pages of addresses and print 50 at a time from the normal paper tray.

https://www.google.com/search?q=Konica+Minolta+Bizhub+880+print+9+x+12+envelopes

Template for Avery 8163 Shipping Labels 2" x 4"

Avery https://www.avery.com > templates > 8163

Avery® Erasable Multi-Use Removable Labels, 7/8" x 2-7/8", W... ... Avery® Printable Tags with Sure Feed, 2" x 3-1/2", White, 96... ... Avery® Easy Peel® Address ...

..

My bizhub c25 jams when printing only colored photocopy. How can I resolve it pls.

Clean the feeder paper feed,separator roller with cloth and alcohol.

Fusing unit life is over or it can be the paper size problem.if you are using manual by pass tray for A3 printing then make sure machine is detecting A3 in manual by pass tray.if its OK then problem is in fusing unit.

Under printer setup select your print, then change the paper size in the settings to the paper you're using.
Change the alignment of the paper feed on printer to the size of the new paper

Hi the machine could be defaulted to print from the main trays if you have the same type paper being fed from the manual feed same size paper then it will automatically take it from the default trays
IF you take the paper out of the trays and put it only in the manual feed will it print and take it from the manual feed also you have to tell the machine when you use the manual feed what size and type of paper is in the manual feed once you tell it what paper and type of paper like card stock you then need to make sure when you go to print that it is set on your computer with manual feed and type of paper must match what is set on machine

The paper may not be feeding straight out of the paper tray due to poor stacking of the paper in the paper cassette. try another paper tray or check the paper in the paper tray for folded over papers usually near the bottom. Also try feeding paper from the hand feed tray on the left side. This uses a different paper path.

Hi Alan,
Please ensure that the printer driver is set correctly.
Go to your Printer & Faxes menu, right click the C250, click printing preferences, click the Quality tab and make sure Colour is selected. Apply the changes and bingo!
The above assumes you are using Windows and a PCL driver.
Hope it helps

Regards

Taminol

That is a common problem especially if you are using a thin paper and an aging machine.

The feed rollers tend to develop dusts which causes the thin papers to slide or crumple in the middle.

Solution would be to clean or replace the feed rollers. Contact your supplier for a service or order service parts such as the feed roller.

Hope this helps. Thank you for using Fixya.

Hi,
C-0206 relates to tray 3.
With the copier turned on do the following
Open paper tray 3, remove paper, close tray, open then shut front door, load paper into tray 3 - hey presto!!
If the fault comes back you could have paper stuck behind the tray or have a defective lift up motor.
Regards
Taminol