Are red wines stored on the top or bottom of the Haier BC112G wine cooler? How about white wine? Have lost my owners manual and don't know where to put red wine when the temp is set cooler for white wine

Our magic chef wine cooler (mcwc50dbt) when temp is set on digital panel at 45-50 it jumps immediately back to 70 degrees constantly

Push & hold the red wine button & the white wine button. This will start the adjustment process. Let go of both & use the plus & minus buttons to control the temp. When you are done hit the light button & the unit will record the new temp.

Hello Ahanaples,

I understand that you are trying to locate a user manual for you Haier BC112G wine coller. I have located the manual on Haier.com the following link will take you to the page then you just have to click on the model of the unit that you have the first one at the top of the page.

http://www.haieramerica.com/en/support/modelsearch

Thank you for choosing FixYa.com

Justin Burnett

http://www.haieramerica.com/en/asset/archived/BC112G.pdf
good lock

The error is likely caused by a bad temperature sensor. The control board may still be Okay.
Replacing both of them is recommended.

Check this link for parts: http://www.partstore.com/Model/HAIER+AMERICA+TRADING/Haier/BC112G.aspx

Power surges, spike and brown-outs are a nemesis to small refrigeration units. The capacitor for the compressor likey was affected and possibly the start components in general, especially if the unit was operating when the surge occured.

call were u buy it

you will have to gently pry it all around with a thin scraper, i am assuming there is no sealer as fluid would not have leaked in if there was.be gentle but forceful.

Haier BC112G service & user manual:

To adjust the temp of your unit:

• Push & hold the red wine & white wine button at the same time.This will start the temp adjust. You will notice the plus sign & the negative sign on these same buttons, use them to adjust temp. When you are done hit the light button & it will record the new temp.
  

That thing that's beeping...it is the circuit board. It is telling you that it wants a new cousin to live in your house. Replace it.