My humax rm-f01 remote has stopped working. The PVR light comes on everytime you press a button but nothing changes on the tv?. I've checked the batteries and they are fine?

Hi John the steps below shows you how to use the remote. If you need more information there's a link included for the Humax website. There you'll find the codes and also setup guides.
https://uk.humaxdigital.com/support/rem_code/

How to use the Universal Remote Control
1. Select the mode(PVR, TV, DVD, AUDIO) you want to set by
pressing the corresponding button on the remote control. The button will blink once.
2. Keep pressing the button for 3 seconds until the button lights on.
3. Enter the 3-digit code. Every time a number is entered, the button will blink. When the third digit is entered, the button will blink twice.
4. If a valid 3-digit code is entered, the product will power off.
5. Press the OK button and the mode button will blink three times. The setup is complete.
6. If the product does not power off, repeat the instruction from 3 to 5.
Note:
• When no code is entered for one minute the universal setting mode will switch to normal mode.
• Try several setting codes and select the code that has the most functions.

I had this problem, perhaps after pressing some keys on the remote control wrongly.

I turned off the TV at the mains. I turned off the PVR at the mains.
I turned both the TV and the PVR back on, and both worked correctly.

Normally repairing circuit boards to remote controls will be very difficult. Even though you get it repaired, the repairing cost might exceed the price of a new one.

from "sceptical Glenn". I had the same problem & saw solutions so thought why not!!!.unplugged box, removed batteries,waited 10 mins.Held down "ON" button for a good minuet.Pressed all buttons from top left to right all the way down"like reading a book" even the ones under the slidey bit.Replaced batteries pressed buttons again in the same sequence,plugged the box back in pointed remote at box held "ON" button down for another minuet, then crossed my fingers.Pressed a button and it worked,"Wheay" success it worked it worked.Never again will anybody call me sceptical Glenn again.Thanks for the solution I am now a happy remote control using person once again, never having to leave my settee again only for a beer,or the loo or food,but that can also be rectified as I sit near the window...the pizza man can pass it through to me.

http://www.humaxdigital.com/global/support/rcucodelist.asp
this website has a few lists you can look at to try to find the code you need to use your remote.

I had exactly the same problem with my Humax remote RM-F01
, I just changed the batteries and it was fine after that..I think because you use one remote for all and batteries are only AAA's, they dont last as long, get some duracells.

Hello,
In the Setup Menu, Go to Remote,
Select your TV Type and try the different codes.

Make sure you have pressed the "PVR" button at the top. If you have accidentally pressed on on the others TV, DVD or AUDIO then they will light up when you press another button signifying that the remote is trying to send a signal to them rather than the PVR...which is where you want it to go.

nor do they for the TX-32LMD70A.

Anyone got a solution. I hate two controllers.

the code is 1323 to manage and operate the HT-Q20