LG Remote Control 6711R1P070B stopped working

Check the remote control for its infra-red emission. Check it with fresh batteries. Check by pressing all the buttons on it; and see whether all of it generates infrared signal while pressing. If it is found OK, check and replace the infrared sensor inside the TV. If you wish to get some details; check the site linked here. It has details about how to check a remote control; by one among the post. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ If the remote control is found OK; check and replace the infra-red sensor inside the TV. Contact any service technician.
https://www.youtube.com/watch?v=F8oYoZslgbs LG Remote control - Open - Search [How to open LG Remote control]
https://www.youtube.com/watch?v=do41DlsZHmA [open, battery change Toshiba]
https://www.youtube.com/watch?v=jsSCNCW3IbQ [open and clean]
https://www.youtube.com/watch?v=Qp-l1uh-5gE [open and clean]

The remote interface of the TV died on mine, it was intermittent then it stopped completely. Remote control is fine, it's the remote sensor in the TV itself.

Does it work without remote OK.

You have to go to service mode menu and adjust. Only service center can help you.

For Time Warner Cable digital remote controls to work with your 42" LG HDTV, do the following:

1. Press "TV" and "OK" simultaneously for 3 seconds, until the button "tv" light on the remote is on.

2. Enter the TV code. In this case, it's "113". With the right code, your component will turn off. Quickly press the power button on your digital cable remote to turn it back on. Press the "TV" button again so that the remote saves that code.

3. You should be done.

I found the DVD LG DVS-8575N manual in spanish on http://safemanuals.com/user-guide-instructions-owner-manual/LG/DVS-8575N-_S


To set a Sony TV just press at the same time POWER TV and number 8 or 9

I found the DVD LG DVS-8575N manual in spanish on http://safemanuals.com/user-guide-instructions-owner-manual/LG/DVS-8575N-_S

Procedure:
Press at the same time POWER TV and a code number.

TV - Code number

LG / Goldstar: 1 or 2
Zenith: 1, 3 or 4
Samsung: 6 or 7
Sony: 8 or 9
Hitachi: 4

The procedure is simple. Hold down the TV POWER button and press a number botton. Release the TV POWER button. The manuel gives the following list of codes: LG/GoldStar....1 (predetermined), 2 Zenith...1, 3, 4 Samsung... 6, 7 Siny... 8, 9 Hitachi... 4
I have an RCA and 6 worked for me.
-olivares1900

Assuming you have not shot your in-laws and are now reading this from a jail cell, if you hold down 'TV POWER' and press number '8' or '9' on the remote, you should get it working again. I've just got a new Sharp bells'n'whistles TV, and the remote doesn't work fot it at all. Bummer!!!

I have a rh 265 remote and lg tv. It stopped controlling the tv. I hold the tv power button down on remote then pushed 1 at the same time. It reset it to work with my tv.

I have the same problem. If you unplug the tv for a while then plug it back in it will work again for a time.