Wfw8300sw01 - makes loud noise sounds during spin

Best guess, failed drum bearings.

Possibly a broken damper.

..

https://www.mumsnet.com/Talk/housekeeping/604039-washing-machine-sounds-like-there-is-something-metal-loose-inside
https://removeandreplace.com/2015/07/27/washing-machine-making-noise-during-the-spin-cycle-how-to-fix/
https://www.espares.co.uk/advice/careandmaintenance/how-to-diagnose-drum-problems-in-a-washing-machine
https://www.appliancesonline.com.au/academy/laundry/6-common-washing-machine-problems-and-how-to-solve-them/

Is it a front loader? You may have something stuck between the tubs or it may be a broken "paddle" One of the plastic baffles that move the clothes around in the tub. they should all be tightly against the tub.

During the spin cycle the drum moves at a higher RPM and so the counter weight of the clothes within can make the drum rotate eccentric or out of sync.
So check if the belt is loose on the motor, checck if the spindle is tight with friction or the drum assembly suspension is out of alignment.
You must check the reason with the following points to confirm the drum spinning making noise. check point of noise , is this on hitting the sides , or from the motor, any foreign objects or the drum spindle. But you are the judge with a first view. Use good lighting to look out and confirm the fault.

Check and see if the inner drum is loose and floppy.if it is, it's likely the bearings have collapsed, and require replacement...If the drum feels stiff and tight, it could be that something is jammed between the inner and outer drums. Both situations could be costly...Get quotes....Good luck...Nomess

the bearings are going bad must be replace.
or if ou are lucky check if there is any thing inside the drum , like asmall piece of metal,,,,,

I just replaced the bearings on my Front loader Maytag MAH5500B, as it sounded like a freight train during the spin cycle. The bearing replacement fixed the train problem.

NEW PROBLEM NOW: It's been about a month now since the bearing job and now something is clicking/binding when you spin the back belt wheel. I have taken the belt off and carefully move the wheel and I still get this clicking noise. It sounds as if someone is hitting the plastic drum that the tub is surrounded by. I really doubt it's the bearings this soon, as the sound is not the same! No leaks or metal shavings to speak of or rubbing of the belt wheel.

Seems like it's more noticeable during the wash/rinse cycles then the spin.

Can anyone help.???

is it more like a roar or a train going by? if so your rear tub bearing is going out. very expensive have to replace the tub, basket, spinner ring and shaft and seals about 4 hrs for an exprienced tech to do took me 7 hrs to do for the first time. but it will be very close to $1000 to have done not much less to do it yourself.

ckd your warranty papers sounds like rear drum support(spider) has broken will require new basket and rear drum half est cost 400-600 spider is not a separate part and rear bearing is probably damaged that too is not a separate part and require rear tub replacement

drum bearings are gone,it would cost too much to repair,the drum shaft would to be repalced as well.Sorry