Keeps tripping breaker, took off shroud and spins easy. took cap off of pressure switch and when trying to start it hums and when turning switch back to off it sparks from the contacts.Whan running 1 capacitor on motor was hot.
Replace both capacitors. There is repair of them. Cheaper Thant a new motor. Ensure that the start contacts are not welded together,
Testimonial: "Pulled capacitors out and seems the start capacitor is bad, leaking the insulation and it was the one that was hot. i'll replace both tomorrow and cross fingers. Thanks"
SOURCE: breaker keeps tripping
If the breaker itself is more than 15 years old, replace it. If it continues to switch off, check the amp draw of both the inside and outside unit.
SOURCE: Starting problems
IF YOUR PRETTY SURE DRAW A CAPACITOR WIRING DIAGRAM AND THEN TAKE YOUR CAPACITORS TO ANY MOTOR SHOP OR SUPPLY HOUSE LIKE WW GRAINGER. THEY CAN CHECK THE MICROFARRADS OR UNIFARRADS OF YOUR CAPACITORS. YOUR START CAPACITORS HAVE THE LARGER MF OR UF RATING AND ARE TYPICALLY LARGER IN SIZE. YOUR P.O.S. INGERSOL RAND MAY EVEN BE A 3500 RPM MOTOR AND COULD HAVE UP TO 5 CAPACITORS. 3 OF WHICH ARE START. IS YOUR WIRE LARGE ENOUGH? IS YOUR BREAKER LARGE ENOUGH? IS YOUR COMPRESSOR UNLOADING THE HEAD PRESSURE WHEN IT CUTS OFF? IS IT OUTSIDE AND TOO COLD IN THE MORNINGS? MAKE SURE YOUR WIRING IS LARGE ENOUGH BECAUSE THAT IS USUALLY THE PROBLEM. YOU HAVE SINGLE PHASE BUT IS YOUR VOLTAGE CORRECT 208V OR 230 V. ALL WIRING AND GAUGING CHARTS ARE BASED ON 100 FT OF WIRE . MOST COMPRESSORS PULL 3 TIMES THE AMP RATING ON INITIAL STARTUP THEN COM DOWN TO AMPS LISTED ON THE MOTOR.
SOURCE: motor hums when turned on
Try this link for help. They suggest emailing before calling:
http://www.mypool.com/introduction.htm
SOURCE: 1 HP electric motor hums but not turning.
check for a re-set button somewhere on the motor housing.
SOURCE: gfci breaker keeps tripping
It may not relate to this problem but my exterior GFCI breaker kept tripping after a winter warm spell. Solved it by drying the breaker with a hair dryer for about 10 minutes. Warm wet air had condensed inside the breaker.
241 views
Usually answered in minutes!
×