Washes till the rinse cycle then stops. I have to shut it off then start on rinse and spin only.
SOURCE: Frigidaire Front Load Washer Problem
Plug off the wall, open up the back to check your belt, might have come off. Place around motor pulley & turn the drum wheel to slip on the belt gently from either the right or left. If too loose you have to replace with new belt.
Rate if helped pl..................
SOURCE: Frigidaire Front Load Washer - does not rinse and spin
sounds like the timer went out replace it should solve problem
SOURCE: Kenmore Front Load Washer, 417.44082400, will not
Hi. this is a failed timer device. simply replacing the timer control module will eliminate these issues you are having.
SOURCE: Ge top load washer, will not spin/rinse but will
Take the front panel off by using a putty knife to release the clips at the top of the front panel. Now, take the thin tube off from the left side of the tub. Clean out the end of the tube, and use a thin wire to clean out the nipple it was pushed onto. Re-attach.
SOURCE: washer wont rinse,spin or drain
you might have a problem with the lid switch..there is a plunger on the bottom side of the lid, close to the front edge which operates the lid switch..if the switch is broken, it probably has become torn apart so, if you can identify the two wires that would've been on the switch, you can just twist them together, tape them and the machine will operate normally, until you can get the switch from Sears... because I have a service contract with Sears, I don't pay for the repair (twice) they normally charge dearly both for the part and labor..
240 views
Usually answered in minutes!
×